Cub Cadet 933 SWE Operator's Manual download pdf (Page 18)

Replacing Shear Pins

Each of the four auger spiral assemblies are secured to the spiral

shaft with a shear pin and cotter pin. If the auger should strike a

foreign object or ice jam, the snow thrower is designed so that

the pins may shear. If the augers will not turn, check to see if the

pins have sheared. See Fig. 5-3.

CAUTION: NEVER replace the auger shear pins with

anything other than OEM Part No. 738-04155

replacement shear pins. Any damage to the auger

gearbox or other components as a result of failing to

do so will NOT be covered by your snow thrower’s

warranty.

WARNING! Always turn off the snow thrower’s

engine and remove the key prior to replacing shear

pins.

Operating Tips

NOTE: Allow the engine to warm up for a few minutes. The

engine will not develop full power until it reaches operating

temperature.

WARNING: The temperature of the muffler and the

surrounding areas may exceed 150° F. Avoid these

areas.

If possible, remove snow immediately after it falls.1.

Discharge snow downwind whenever possible. 2.

Slightly overlap each previous path.3.

Set the skid shoes 1/4” below the shave plate for normal 4.

usage. Adjust them upward for hard-packed snow and

downward when using on gravel or crushed rock.

Figure 5-3

Shear Pins

Bow-Tie Pins

18 se c t i O n 5— Op e r a t i O n

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

No comments

Cub Cadet 933 SWE Operator's Manual Page 18