Cub Cadet 933 SWE Operator's Manual download pdf (Page 29)

Troubleshooting

Problem Cause Remedy

Engine fails to start Choke not in CHOKE position.1.

Spark plug wire disconnected.2.

Fuel tank empty or stale fuel.3.

Engine not primed.4.

Faulty spark plug. 5.

Safety key not in ignition on engine.6.

Extension cord not connected (when 7.

using electric start button, on models so

equipped).

Move choke to CHOKE position.1.

Connect wire to spark plug.2.

Fill tank with clean, fresh gasoline.3.

Prime engine as instructed in “Operating 4.

Your Snow Thrower”.

Clean, adjust gap, or replace.5.

Insert key fully into the switch.6.

Connect one end of the extension cord to 7.

the electric starter outlet and the other end

to a three-prong 120-volt, grounded, AC

outlet.

Engine runs erratic /

inconsistent RPM (hunting

or surging)

Engine running on CHOKE.1.

Stale fuel.2.

Water or dirt in fuel system.3.

Carburetor out of adjustment.4.

Over-governed engine.5.

Move choke lever to RUN position.1.

Fill tank with clean, fresh gasoline.2.

Drain fuel tank. Refill with fresh fuel.3.

Contact an authorized Service Center.4.

Contact an authorized Service Center.5.

Engine overheats Carburetor not adjusted properly.1. Contact an authorized Service Center.1.

Excessive vibration Loose parts or damaged auger.1. Stop engine immediately and disconnect 1.

spark plug wire. Tighten all bolts and nuts. If

vibration continues, have unit serviced by an

authorized Service Center.

Loss of power Spark plug wire loose.1.

Gas cap vent hole plugged.2.

Connect and tighten spark plug wire.1.

Remove ice and snow from gas cap. Be 2.

certain vent hole is clear.

Unit fails to propel itself Drive control cable in need of adjustment. 1.

Drive belt loose or damaged.2.

Friction wheel worn.3.

Adjust drive control cable. Refer to 1.

Maintenance section

Replace drive belt.2.

Replace Friction Wheel.3.

Unit fails to discharge snow Chute assembly clogged. 1.

Foreign object lodged in auger. 2.

Auger control cable in need of adjustment.3.

Auger belt loose or damaged.4.

Shear pin(s) sheared.5.

Stop engine immediately and disconnect 1.

spark plug wire. Clean chute assembly and

inside of auger housing with clean-out tool

or a stick.

Stop engine immediately and disconnect 2.

spark plug wire. Remove object from auger

with clean-out tool or a stick.

Refer to Auger Control Test.3.

Refer to Maintenance section.4.

Replace with new shear pin(s).5.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Cub Cadet 933 SWE Operator's Manual Page 29

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 933 SWE