Cub Cadet 933 SWE Operator's Manual download pdf (Page 12)

WARNING! Do not over-tighten the cable. Over-

tightening may prevent the auger from disengaging

and compromise the safety of the snow thrower.

If adjusting the auger cable, thread the lock nut outwards 4.

towards end of thread to lengthen the cable as necessary

to stop the auger from turning when the control is

released.

Securely hook each cable’s spring into the rear-ward most 5.

hole of the respective actuator bracket. Both cables hook

into the rear-ward most hole of its bracket.

Repeat the wheel drive and auger control tests to verify 6.

proper adjustment. Repeat previous steps if necessary to

attain proper adjustment of each cable.

Adjusting Drive and Auger Controls

From beneath the handle, pull downward on the 1.

appropriate cable and unhook the spring found on the end

of the cable from its respective actuator bracket. Refer to

Figures 3-11 and 3-12.

Slide the spring up the cable to expose the cable coupler 2.

threads and lock nut. Refer to Figure 3-13.

Adjust the lock nut as follows: If adjusting the drive 3.

cable, thread the lock nut outward (down the coupler) to

lengthen the cable and allow the unit to move freely when

the control is released. Thread the lock nut inward (up

the coupler) to shorten the cable to reduce slippage and

prevent the machine from being easily moved with the

drive control engaged.

Figure 3-13

Rearward most hole of

the actuator brackets

Figure 3-12

12 se c t i O n 3— as s e M b l y & se t -up

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Cub Cadet 933 SWE Operator's Manual Page 12