Cub Cadet 933 SWE Operator's Manual download pdf (Page 11)

Auger and Drive Control Cables

WARNING! Prior to operating your snow thrower,

carefully read and follow all instructions below.

Perform all adjustments to verify your snow thrower is

operating safely and properly.

Testing Auger Drive Control

When the au1. ger control is released and in the disengaged

“up” position, the cable should have very little slack. It

should NOT be tight. Refer to Figure 3-11.

Figure 3-10

Figure 3-11

Raise

Shave

Plate

Lower

Shave

Plate

Shave Plate

In a well-ventilated area, start the snow thrower engine as 2.

instructed in the Operation section of this manual. Make

sure the throttle is set in the FAST position.

While standing in the operator’s position (behind the snow 3.

thrower), engage the auger.

Allow the auger to remain engaged for approximately ten 4.

(10) seconds before releasing the auger control. Repeat this

several times.

With the throttle control in the FAST (rabbit) position and 5.

the auger control in the disengaged “up” position, walk to

the front of the machine.

C6. onfirm that the auger has completely stopped rotating

and shows NO signs of motion. If the auger shows ANY

signs of rotating, immediately return to the operator’s

position and shut off the engine. Wait for ALL moving parts

to stop before re-adjusting the auger control.

Testing Drive Control & Shift Lever

With the engine turned off, move the speed selector lever 1.

into sixth (6) position. Refer to Figure 3-11.

With the wheel drive control released, push the snow 2.

thrower forward, then pull it back. The machine should

move freely.

Engage the drive control and attempt to move the machine 3.

both forward and back, resistance should be felt.

Move the shift lever into the fast reverse (R2) position and 4.

repeat the previous two steps.

If you experienced resistance rolling the unit, either 5.

when repositioning the shift lever from 6 to R2 or when

attempting to move the machine with the drive control

released, adjust the drive control immediately. See

Adjusting Drive and Auger Controls.

Drive

Control

Drive

Control

Cable

Auger

Control

Auger

Control

Cable

Speed Selector Lever

Chute Tilt Control

11se c t i O n 3 — as s e M b l y & se t -up

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Cub Cadet 933 SWE Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 933 SWE