Cub Cadet 933 SWE Operator's Manual download pdf (Page 7)

Assembly

IMPORTANT: Two replacement auger shear pins are included

with this manual (or stowed in the plastic handle panel). Refer to

the Maintenance section for more information regarding shear

pin replacement.

NOTE: All references in this manual to the left or right side of the

snow thrower is from the operating position only. Exceptions, if

any, will be specified.

IMPORTANT: This unit is shipped with the engine full of oil.

After assembly, refer to the Engine Maintenance section of this

manual for fuel and oil fill-up details.

NOTE: Specifications are subject to change without notification

or obligation. Images may not reflect your exact model and are

for reference purposes only.

Handle

Remove any packaging material from the upper handle. 1.

Remove the lower plastic wing nut, belleville washer and 2.

carriage bolt from each side of the upper handle; then raise

the upper handle assembly until it snaps over the lower

handle. See Figure 3-1.

Looking beneath the handle panel, check that all of the 3.

cables (steering, auger, shift, and drive) are properly routed

and not pinched or kinked. Make certain the springs at the

lower end of the auger and drive cables are securely hooked

into their respective actuator bracket.

Secure the upper handle and lower handle with the two 4.

wing nuts, belleville washers, and carriage bolts removed

earlier. Tighten the two wing nuts already installed in the

upper holes to firmly secure the upper handle and support

tubes. See Figure 3-2.

Contents of Carton

One Snow Thrower• Two Replacement Auger Shear Pins• One Chute Assembly•

One Snow Thrower Operator’s •

Manual

One Product Registration Card•

Figure 3-2

Figure 3-1

Assembly & Set-Up

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

Cub Cadet 933 SWE Operator's Manual Page 7