Cub Cadet 933 SWE Operator's Manual download pdf (Page 10)

Remove the oil filler cap/dipstick. If the level is low, slowly 3.

add oil until oil level registers between high (H) and low

(L), Fig. 3-9. Refer to the Engine Maintenance section for

correct oil viscosity and engine oil capacity.

NOTE: Do not overfill. Overfilling with oil may result in

engine smoking, hard starting or spark plug fouling.

Replace and tighten cap/dipstick firmly before starting 4.

engine.

Adjustments

Skid Shoes

The snow thrower skid shoes are adjusted upward at the factory

for shipping purposes. Adjust them downward prior to operating

the snow thrower.

CAUTION: It is not recommended that you operate

this snow thrower on gravel as it can easily pick up and

throw loose gravel, causing personal injury or damage

to the snow thrower and surrounding property.

For close snow removal on a smooth surface, adjust the skid

shoes so that the shave plate on the bottom of the auger

housing is just off the ground.

Adjust the skid shoes to a lower position to raise the shave plate

off the ground when clearing uneven areas, or a gravel driveway.

NOTE: If you choose to operate the snow thrower on a gravel

surface, keep the skid shoes in position for maximum clearance

between the ground and the shave plate.

To adjust the skid shoes:

Adjust skid shoes by loosening the six (three on each side) 1.

hex nuts, washers, and carriage bolts securing the skid

shoes to the auger housing. Refer to Figure 3-10.

While observing the distance between the shave plate and 2.

the ground, adjust the skids shoes up or down to achieve

the desired shave plate height.

Make certain the entire bottom surface of skid shoes are 3.

against the ground to avoid uneven wear on the skid shoes;

then tighten nuts and bolts securely.

Adding Fuel

WARNING! Use extreme care when handling

gasoline. Gasoline is extremely flammable and the

vapors are explosive. Never fuel the machine

indoors or while the engine is hot or running.

Extinguish cigarettes, cigars, pipes and other

sources of ignition.

WARNING! Always keep hands and feet clear of

equipment moving parts. Do not use a pressurized

starting fluid. Vapors are flammable.

Clean around fuel fill before removing cap to fuel.1.

A fuel level indicator is located in the fuel tank. Fill tank 2.

until fuel reaches the fuel level indictor, Fig. 3-8. Be careful

not to overfill.

Checking Oil Level

CAUTION: The engine is shipped with oil in the

engine. You must, however, check the oil level prior

to operating the snow thrower. Running the engine

with insufficient oil can cause serious engine

damage and void the engine warranty.

NOTE: Be sure to check the engine on a level surface with the

engine stopped.

Remove the oil filler cap/dipstick and wipe the dipstick 1.

clean. See Fig. 3-9.

Insert the cap/dipstick into the oil filler neck, but do 2. NOT

screw it in.

IMPORTANT: Do not screw the cap/dipstick in when checking

the oil level.

Fill

between

high

and low

marks

Fuel Level Indicator

Top View

Figure 3-9

Figure 3-8

10 se c t i O n 3— as s e M b l y & se t -up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Cub Cadet 933 SWE Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 933 SWE