Cub Cadet 933 SWE Operator's Manual download pdf (Page 24)

Belt Replacement

Belt Removal Preparation

Remove the chute crank assembly bracket by removing 1.

the nuts and washers shown in Fig. 8-1.

Remove the plastic belt cover on the front of the engine 2.

by removing the three self-tapping screws. See Fig. 8-2.

Loosen the bolt shown in Fig. 8-3 securing the belt 3.

keeper bracket and remove the other bolt. Push the belt

keeper bracket up off the engine pulley. See Fig. 8-3.

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt,

proceed as follows:

Remove the bow tie clip and flat washer from the 1.

ferrule in order to disconnect the auger idler rod from

the brake bracket assembly. See Fig. 8-4.

NOTE: Make sure to maintain the location of the

ferrule on the idler rod.

Slip the auger control belt (the front belt) off the engine 2.

pulley.

Figure 8-4

Figure 8-1

Figure 8-2

Figure 8-3

Nuts &

Washers

Loosen

Remove

Ferrule

Auger Idler Rod

Hairpin Clip

and Washer

Service

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

Cub Cadet 933 SWE Operator's Manual Page 24