Cub-cadet Z-Force Series User Manual download pdf (Page 30)

Z Force

13.7. The bushings can be driven out and replaced if

necessary. See Figure 13.7.

13.8. The pivot bolt can be removed using a pair of

1 1/2” wrenches. See Figure 13.8.

NOTE: On installation, tighten the pivot bar nut

and bolt until front-back play is gone from the

pivot bar, but not so tight that movement is inhib-

ited by friction.

13.9. The pivot bar can be withdrawn once the pivot

bolt is removed. See Figure 13.9.

NOTE: The pivot bar is off-set to the front. This

provides room for the caster wheels to swivel

without deck interference.

13.10.The bushings that support the pivot bar can be

easily driven out for replacement.

13.11. When installing the pivot bar, tighten the nut until

a slight bind is placed on the pivoting action,

then loosen the bolt until the bind just goes

away.

Figure 13.7

Grease zirch

Pivot bar

Upper bushing

Figure 13.8

Really big Crescent wrench

Figure 13.9

Forward

Long side of

pivot hub

Short side of

pivot hub

1 2 ... 25 26 27 28 29 30 31 32 33 34

No comments

Cub-cadet Z-Force Series User Manual Page 30