Cub-cadet Z-Force Series User Manual download pdf (Page 17)

Z Force

9.3. To adjust the reverse switch bracket, loosen the

machine screws that hold the reverse switch

bracket to the control housing using a 5/16”

wrench. See Figure 9.3.

NOTE: There is one screw on each switch that is

accessible from outside the control console, and

one that cannot be reached without removing

the control console

NOTE: The switch being adjusted should be just

loose enough to allow the reverse switch bracket

to be moved with light pressure.

9.4. Turn the key switch to the “ON” position, but do

not start the engine.

9.5. Pull forward on the lap bar that operates the

reverse switch to be adjusted. Pull forward just

far enough to take-up any play in the linkage, so

that the control quadrant on the IHT is just at the

“forward” edge of the neutral range.

9.6. Pivot the reverse switch bracket back, until an

audible “click” is heard, as the PTO clutch disen-

gages.

9.7. Tighten the screws, and double-check the

adjustment. See Figure 9.8.

Figure 9.3

Reverse switch bracket

screw (accessible

from outside)

Reverse switch bracket

screw (only accessible by

removing control console)

Blue wires

9.8. Repeat this adjustment on the opposite side

reverse switch.

9.9. If shop noise prevents the technician from

clearly identifying the “click” from the electric

PTO clutch, a 12V test light may be installed in

the lead that connects to the PTO clutch.

See Figure 9.9.

9.10. Install both control consoles when adjustment is

complete.

NOTE: install the control consoles with two bolts

each for testing purposes. After correct opera-

tion is confirmed, install all of the mounting bolts

in each control console.

Figure 9.8

Switch adjustment range

One screw is accessible

from outside the control

console

The other screw must be

reached from inside the

control console.

Figure 9.9

Blue wires from

reverse switches

Green ground wires

PTO clutch

Install test light here if unable to

hear the PTO clutch because of

background noise.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Comments to this Manuals

No comments

Cub-cadet Z-Force Series User Manual Page 17

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet Z-Force Series