Cub-cadet Z-Force Series User Manual download pdf (Page 10)

Z Force

6.5. Check the IHT (Integrated Hydrostatic transmis-

sion) release the levers to be sure the transmis-

sions are fully engaged. See Figure 6.5.

6.6. Check steering linkage for wear and damage.

i.e.; loose ball joint ends, worn bellcrank bush-

ings, and loose or bent hardware.

6.7. Replace any worn or damaged components

before attempting to make a tracking adjust-

ment.

6.8. After the preliminary items have been covered,

check the neutral adjustment.

6.9. Raise rear wheels off ground and support the Z-

Force by the frame.

6.10. Start the engine and release parking brake, do

not move the lap bars from the start position.

Neither the rear wheels nor the brake rotors

should move. See Figure 6.10.

6.11. Turn the engine off and remove the key from the

switch.

6.12. If there is wheel movement in neutral, discon-

nect the control linkage from the transmission

that is driving that wheel.

NOTE: If both wheels “creep” then both control

linkages need to be disconnected.

6.13. Using two 1/2” wrenches, remove the Nylock nut

holding steering link rod end to the return-to-

neutral mechanism. See Figure 6.13.

6.14. With the steering link rod disconnected, start the

engine, release the parking brake, and check for

wheel and brake rotor movement.

6.15. If “creep” has been eliminated by disconnecting

the linkage, then only the linkage must be

adjusted to eliminate the “creep”. If “creep” still

exists, then the return-to-neutral mechanism on

the transmission must be adjusted.

Figure 6.5

Release rod for right

hand side IHT, seen at

rear of frame.

Released position; lift

Forward end of the same

rod, connected to lever on

right hand side IHT.

IHT release rod

IHT release

lever

and push in to engage

Figure 6.10

Parking brake

released

Leave the lap bar in the

“START” position

notch. This will hold

the lap bar in neutral.

Figure 6.13

Return-to-neutral mechanism

Steering

link rod end

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Comments to this Manuals

No comments

Cub-cadet Z-Force Series User Manual Page 10

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet Z-Force Series