Cub-cadet Z-Force Series User Manual download pdf (Page 11)

Z Force

6.16. To adjust the return-to-neutral mechanism,

loosen the socket head cap screw that locks the

indexing plate on the return-to-neutral mecha-

nism in position using a 1/4” allen wrench. It

should be possible to move the indexing plate

with light effort. See Figure 6.16.

6.17. Temporarily disable the seat safety switch.

Because the plug has a double-safety, simply

unplugging the switch has no effect. Applying

pressure to the part of the seat normally occu-

pied by the operator’s gluteus maximus will

extend the three tabs. Clamping one of those

tabs with a pair of alligator clips or a similar tool

will hold the switch in the actuated position.

See Figure 6.17.

6.18. Insure that no unsafe conditions will be created

by starting the engine and operating the drive

system.

Figure 6.16

Indexing plate

Rotate entire mechanism to adjust

cap screw

Socket head

Figure 6.17

Seat safety switch

tabs

6.19. Start the engine. Carefully rotate the return-to-

neutral mechanism until a position is found that

results in no “creep”.

6.20. Tighten socket head cap screw. Confirm that the

adjustment did not shift as the screw was tight-

ened.

6.21. Repeat the procedure on the second IHT, if nec-

essary

6.22. Turn the engine off, and remove the key from the

key switch.

6.23. Reattach steering link rod.

6.24. Enable the seat safety switch.

6.25. The steering link rods can be lengthened or

shortened to adjust tracking.

6.26. Loosen the jam nuts on the link that connects

the bellcrank to the return-to-neutral mechanism.

See Figure 6.27.

NOTE: One end of the steering link rod has a

right hand thread, the other end has a left hand

thread. When both jam nuts are loose, the steer-

ing link rod can be rotated to make a length

adjustment.

NOTE: When adjusting the steering link rods,

maintain sufficient engaged thread length within

the rod end.

Figure 6.26

Bellcrank

Link

Jam nuts

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Comments to this Manuals

No comments

Cub-cadet Z-Force Series User Manual Page 11

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet Z-Force Series