Cub-cadet Z-Force Series User Manual download pdf (Page 15)

Z Force

8.7. Check the brake lever mounting hardware.

See Figure 8.7.

8.8. Prior to adjustment, check the brake pawls and

rotors. See Figure 8.8.

• The teeth on the pawls and rotors should not be

worn, chipped or rounded.

• Both ends of the brake shaft on each transmis-

sion are splined. The brakes are mounted to the

outside of each transmission.

• The right side brake rotor fits on the brake shaft

with the shoulder facing the transmission.

• The shoulder on the pawl should face in the

same direction as the shoulder on the rotor that

it engages. The pawl should not bind on the

shoulder of the bolt that it pivots on.

Figure 8.7

Nut

Friction washer

Parking brake lever

Spacer

Flat washer

Capscrew

Spring

Figure 8.8

Adjustment point

Brake rotor

Brake pawl

8.9. Prior to adjustment, check the brake pawls and

rotors. See Figure 8.9.

• The teeth on the pawls and rotors should not be

worn, chipped or rounded.

• Both ends of the brake shaft on each transmis-

sion are splined. The brakes are mounted to the

outside of each transmission.

• The left side brake rotor fits on the brake shaft

with the shoulder facing the wheel.

• The shoulder on the pawl should face in the

same direction as the shoulder on the rotor that

it engages. The pawl should not bind on the bolt

that it pivots on.

8.10. Pull out both hydro. pump rods to disengage the

hydraulic brakes.

8.11. Install the left side control console.

8.12. Move the parking brake lever to the ON position.

8.13. Check for full tooth engagement between each

brake pawl and rotor. If they are not fully

engaged, move the corresponding rear hub

slightly to align the teeth.

Figure 8.9

Shoulder

Shoulder out.

Right side brake rotor:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Comments to this Manuals

No comments

Cub-cadet Z-Force Series User Manual Page 15

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet Z-Force Series