Cub-cadet Z-Force Series User Manual download pdf (Page 28)

Z Force

12.3. Lift the control housing over the brake lever, if

working on the left side control console, and set

it out of the way.

NOTE: The throttle cable will still be attached to

the left side control console. Be careful no tot

damage it.

NOTE: Disconnect any electrical components

that inhibit the movement of the control console.

12.4. Remove the nut and socket head cap screw that

hold the pivot bracket to the steering input shaft

using a 1/4” Allen wrench and a 1/2” wrench.

See Figure 12.4.

12.5. Slide the lap bar and pivot bracket assembly off

of the steering input shaft.

NOTE: If the socket head cap screw has left a

burr on the steering input shaft, de-burr the shaft

before attempting to remove it.

12.6. Push the steering input shaft into the control

housing far enough to allow the removal of the

outside bushing.

12.7. Remove the outer bushing, and push the inner

bushing out of the hexagonal hole that it resides

in. See Figure 12.7.

12.8. Maneuver the steering input shaft into a vertical

position so that it and the inner bushing can be

removed. See Figure 12.8.

12.9. Replace any parts that are worn or damaged,

and install the steering input shaft by reversing

the removal process.

Figure 12.4

Socket head

cap screw

Pivot bracket

Steering input

shaft

Figure 12.7

Outer

bushing

Steering input shaft

Figure 12.8

Inner hex bushing

Inner bracket

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Cub-cadet Z-Force Series User Manual Page 28

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet Z-Force Series