Cub-cadet Z-Force Series User Manual download pdf (Page 26)

Z Force

11.20. Loosen the bolts that hold the back of the gas

tank to the frame at least three turns using a

9/16” wrench. See Figure 11.20.

11.21. Loosen the bolts that hold the back of the utility

bin to the frame at least three turns using a

9/16” wrench.

11.22. Remove the bolts that hold the front of the fuel

tank and the utility bin to the front tank mounting

bracket using a 9/16” wrench. See Figure 11.22.

11.23. Remove the bolts that hold the control housing

to the frame using a 3/8” socket.

See Figure 11.23.

NOTE: There are three bolts along the front

edge that come down from the top. Two bolts are

accessible from the bottom on each side. Two

bolts are accessible from above on the rear cor-

ners of the control housing.

11.24. Lift the front of the control housing and support it

with a 4 X 4 or similar dimensional lumber.

See Figure 11.24.

11.25. Push the lift shaft assembly up into the top of the

control housing, allowing the arms to hang

straight down.

NOTE: Do not cock the lift shaft assembly when

manipulating it, or it will get stuck.

Figure 11.20

Rear fuel tank mounting bolts

Figure 11.22

Front fuel tank mounting bolts

Figure 11.23

Control housing bolts

Figure 11.24

Frame

Control housing

J-nuts

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Cub-cadet Z-Force Series User Manual Page 26