Cub Cadet M467 Operator's Manual download pdf (Page 8)

8 sectiOn 4— cOntrOls and features

Engine Over-Temp Light

The engine over-temp light (red) is located on the dash panel on

the right side of the warning light cluster. When lit, this indicates

that the engine is running too hot, and MUST be immediately

shut off and allowed to cool.

Ignition Switch

WARNING: Never leave a running machine

unattended. Always set parking brake, stop engine

and remove key to prevent unintended starting.

The ignition switch is located to the right of the steering wheel

on the left side of the dash panel. To start the engine, insert the

key into the ignition switch and turn clockwise to the START

position. Release the key into the Run position once engine has

fired. See Fig. 4-1.

Refer to Starting The Engine in the Operation Section of this

manual for detailed starting instructions.

Warning Light Cluster

The warning light cluster is located in the middle of the dash

panel. See Fig. 4-2. There are four warning lights: alternator

discharge light (Battery), parking brake light, engine oil pressure

light, and low fuel light.

The engine oil pressure light activates when engine has low oil

pressure. The alternator discharge light will indicate that the

alternator is not charging. The low fuel light activates when fuel

is low in the tank. The parking light indicates that the parking

brake is engaged.

Hour Meter

The hour meter is located in the center of the warning light

cluster. It reads the elapsed time engine has run. See Fig. 4-2.

Accelerator Pedal

The accelerator pedal is located on the right side of the floor

beneath the dash panel. Depressing the accelerator pedal will

move the vehicle in the direction selected on the gearshift. As

the pedal is depressed, speed will increase to the maximum

selected range. Releasing the pedal reduces the speed, but does

not stop the vehicle. The brake must be applied to stop vehicle.

See Fig. 4-1.

Brake Pedal

The brake pedal is located on the left side of the floor beneath

the dash panel. Remove foot from accelerator pedal apply

pressure to the brake pedal evenly until vehicle slows down and

stops. See Fig. 4-1.

Parking Brake Lever

The parking lever is located to the left of the driver’s seat. It holds

the brake in the engaged position for parking. See Fig. 4-1.

To engage the parking lever, place shift lever in Neutral, push

brake pedal down firmly, pull up on the parking brake lever, and

release foot from brake pedal. Brake pedal will stay down and

parking brake light on dash will come on to indicate parking

brake is engaged.

To release parking brake, push down on brake pedal and parking

brake latch will release.

NOTE: There is a buzzer which will become activated (audible

sound) when the parking brake is engaged and the unit is not in

Neutral.

Shift Lever

The shift lever is located in the center console between

the seats and has four positions, FORWARD, LOW,

NEUTRAL, and REVERSE. The brake pedal must be

depressed and the utility vehicle must not be in motion

when the moving shift lever.

NOTE: To shift into LOW, move the shift lever from the

neutral position towards the passenger seat and then

forward.

IMPORTANT: Never force the shift lever. Doing so

may result in serious damage to the utility vehicle’s

transmission.

Differential Lock Lever

The differential lock lever is located in the center console

between the seats. When engaged, the differential lever locks

the differential so both drive wheels will pull equally when rear

wheels start to slip. See Fig. 4-1.

Check Engine Light

The check engine light (red) is located on the dash panel on the

left side of the warning light cluster. See Fig. 4-1. When lit, take

unit to your Cub Cadet dealer for a diagnostic test.

HOURS 1/10

FUEL

PARK

BRAKE

OILBATT.

Figure 4-2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Cub Cadet M467 Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Cars Cub Cadet M467