Cub Cadet M467 Operator's Manual download pdf (Page 14)

14 sectiOn 6— Maintenance & adjustMents

WARNING: Coolant is a toxic substance. Dispose in

an environmentally safe manner. Contact your area

EPA office for proper disposal methods and

recycling center locations.

Reinstall the drain plug and turn clockwise until fully

tightened.

Turn the radiator cap counterclockwise to the first

stop, then push downward on the cap and turn

counterclockwise to remove.

In stages, SLOWLY pour the coolant solution into the filler

neck, allowing as much air as possible to escape through

the neck. Fill to the overflow flange of the filler neck.

Wait a few minutes to allow air to escape through the filler

neck and refill as needed, then reinstall the radiator cap.

Fill the overflow reservoir to the “FULL” mark.

Start the engine and allow it to run for a short period. Stop

the engine.

Recheck the coolant level in the overflow reservoir and

refill as needed. Reinstall the reservoir cap.

Cooling System Hoses

Check the cooling system hoses and fan belt for any cracks or

deterioration after every 100 hours of operation. Check for loose

hose connections. Replace any damaged hoses and tighten any

loose connections. Replace a worn or damaged fan belt.

Transfer Case Oil

WARNING: The fluid for your transmission has

been specially formulated to ensure the safe and

proper operation of your vehicle. When changing

the transmission fluid replace it with 80W-90 Shell

Dentax Low Foam Oil. Failure to use 80W-90 Shell

Dentax Low Foam Oil may result in a failure of the

drive system which could result in property damage

or personal injury. DO NOT substitute.

Check the transfer case oil every 100 hours or yearly and change

it at the first 50 hours and then again at 500 hours.

Park vehicle on level surface, place shift lever in Neutral,

and apply parking brake.

Allow transmission sufficient time to cool before

attempting any maintenance or repairs.

Raise and secure cargo box, if manual lift.

10.

11.

12.

13.

Access drain plug through slot on underside of machine

and remove plug. See Fig. 6-2.

Check O-ring on drain plug and replace if missing or in

poor condition.

Install and tighten drain plug.

IMPORTANT: Dirt and debris in oil may cause damage to

transfer case. Clean area around opening before removing

oil cap.

Remove oil cap and add approximately 64 oz of 80W-90

Shell Dentax Low Foam Oil.

NOTE: If necessary, you may remove the fill level plug to

assist with determining the level to which the transmission

may be filled. See Fig. 6-2. When oil begins coming out of

fill level opening, the transmission is full. Replace fill level

plug when finished.

Install oil cap, and lower and latch cargo box.

Figure 6-2

Oil Cap

Fill

Level

Plug

Drain

Plug

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments

Cub Cadet M467 Operator's Manual Page 14

Comments to this Manuals

Related products and manuals for Cars Cub Cadet M467