CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Printed In USAOp e r a t O r ’s Ma n u a lSafe Operation Practices • Set-Up • Operation • Ma
10 se c t i O n 4— cO n t r O l s a n d fe a t u r e sNOTE: Every 50 hours a “change oil” message will flash on the display for 2 minutes every tim
Operation511Filling Fuel TankStop vehicle on a level surface and apply parking brake.1. Turn the ignition key to the STOP position and remove the 2. k
12 se c t i O n 5— Op e r a t i O nEngaging 4x4The 4x4 switch is located on the right side of the dash panel. See the Controls & Features section
13se c t i O n 5 — Op e r a t i O nTowing LoadsWARNING: To help prevent personal injury due to loss of control or tipping, always tow a load slowly e
Maintenance & Adjustments614EngineAir FilterThe engine air filter should be changed every 50 hours. Change more frequently if operated in extremel
15se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t sIf the overflow reservoir is empty, the radiator cap should be removed and the coo
16 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t sCharging BatteryWARNING: Charge battery in a well ventilated area and keep away fr
17se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t sFront and Rear ShocksInspect the front and rear shocks every 100 hours or once a y
Service718FusesUnlatch and lift hood forward to get access to under the 1. dash panel.Remove fuse holder cover. See Fig. 7-2.2. Remove the appropriate
19se c t i O n 7 — se r v i c eWheelsWARNING: Using an unstable lifting device and vehicle support may result in bodily injury. Use a safe lifting de
Customer SupportIf you have difficulty assembling this product or have any questions regarding the controls, operation, or maintenance of this machine
Maintenance Chart820* Change at the first 50 hours, then again at 500 hours.^ Change more frequently if unit is operated in extremely dusty conditions
Accessories921NOTE: Availability of these accessories are subject to change. Please see your local Cub Cadet service dealer for the latest information
Specifications1022NOTE: Specifications subject to change without notice.Engine/ElectricalMake 31HP* Kohler® Aegis EFIType/ Cylinders 4 Cycle Gas/ 2 Cy
Troubleshooting1123Problem Cause(s)Engine will not start Battery has low voltage.1. Loose or corroded battery connections.2. Fuse is blown.3. Spark pl
24 se c t i O n 11 — tr O u b l e s h O O t i n gProblem Cause(s)Engine overheats Air cleaner element missing or plugged.1. Engine oil low.2. Engine
25se c t i O n 11 — tr O u b l e s h O O t i n gProblem Cause(s)Battery will not take a charge Dead battery.1. Loose or corroded connections.2. Sulfa
FEDERAL and CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONSThe California Air Resources Board, the United States En
WARRANTED PARTS:The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from such warranty coverage i
The limited warranty set forth below is given by Cub Cadet LLC with respect to new merchandise purchased and used in the United States, its possession
Important Safe Operation Practices23OperationGeneral OperationRead, understand, and follow all instructions on the vehicle 1. and in the manual before
4 se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e sAvoid driving through water, since loss of control may 16. occur. Driv
5se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e sAvoid loads which exceed the physical dimensions of cargo 5. box. Go sl
6 se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e sNever over fill fuel tank. Fill tank to no more than ½ h. inch below b
7se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e sWARNING: Your Responsibility—Restrict the use of this power machine to
Controls and Features48Read this operator’s manual, safety labels, and operating instructions on the vehicle before operating. Compare the illustratio
9se c t i O n 4 — cO n t r O l s a n d fe a t u r e sEngine Over-Temp LightThe engine over-temp light (red) is located on the dash panel on the rig
Comments to this Manuals