Cub Cadet M467 Operator's Manual download pdf (Page 9)

9Se c t i o n 4 — co n t r o l S a n d Fe a t u r e S

NOTE: Every 50 hours a “change oil” message will flash on the

display for 2 minutes every time the tractor is started. This

message will repeat for the first two after each 50 hour interval.

The oil pressure indicator light will also flash when this display is

active. Before the interval expires, change the crankcase oil level

as instructed in the Engine Manual.

4x4 Switch

The 4x4 switch is located on the right side of the dash panel.

Push in top/bottom of switch to activate or deactivate 4x4

capability. See Fig. 4-1.

12V Power Outlet

The 12V power outlet is located in the center of the dash panel.

It is used for the convenience of plugging in accessories that

require a power source with a maximum load of 5 amps at 12

volts. See Fig. 4-1.

Cup Holders

The cup holders are located between the seats. They are

designed for the use of non-alcoholic beverages.

WARNING: Never operate this vehicle while under

the influence of alcohol or drugs. Doing so can

result in serious personal injury or death.

Seats

The passenger seat is secured with a wing nut located on the

interior corner of the seat plate, underneath the seat belt. See

Fig. 4-1 insert. To lift the seat remove the wing nut, then lift the

seat.

The driver seat has a tool box underneath it, which can be

easily accessed by lifting the seat. This box may be removed by

removing the two screws securing it to the frame for easy access

to belts, etc.

Seat Belts

The seat belts are located on either side of the driver and

passenger seats. When used together with the OPS (Rollover

Protective Structure) they are effective in reducing injuries to the

operator in the event of an accidental rollover.

WARNING: Always wear the seat belt when

operating the utility vehicle equipped with a OPS.

However, if the OPS is not present or has been

removed, the seat belt must not be used.

Adjustable Seat Lever

The adjustable seat lever is located beneath the driver’s seat

on the front side and it is used to move the seat forward and

backward. See Fig. 4-3.

Slide the lever to the left and push the seat forward or back to

the desired position. Release the lever so that it locks the seat in

place.

WARNING: Make sure seat is in locked position prior

to operation and do not try to adjust the seat

position while operating the vehicle.

Cargo Box

The cargo box is raised by a gas spring. Manually remove the

contents of the cargo box before lifting the cargo box. Pull up on

the release latch located behind the driver’s seat and lift up the

cargo box. Once the cargo box is in the raised position, access to

the engine is possible. If equipped with a electrical lift, the cargo

box can be raised to dump cargo.

IMPORTANT: Do not exceed the vehicle’s Total Load Capacity

of 1,400 lb., which includes driver, passenger, accessories, and

cargo. Do not exceed 1000 lbs. in the cargo box.

Figure 4-3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Cub Cadet M467 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Cars Cub Cadet M467