Cub Cadet M467 Operator's Manual download pdf (Page 19)

19sectiOn 7 — service

Wheels

WARNING: Using an unstable lifting device and

vehicle support may result in bodily injury. Use a

safe lifting device and supports to work on raised

vehicle.

Stop the vehicle on a level surface and apply parking brake.

Turn the ignition key to the STOP position and remove the

key.

Loosen but do not remove the five lug nuts from the axle

hub. See Fig. 7-3.

Raise rear/front of vehicle with a safe lifting device and

place support stands under vehicle frame.

WARNING: When lifting the rear of the vehicle for

any reason, DO NOT engage the rear wheels. Even if

the 4x4 switch is in the OFF position, there is a

possibility that the front wheels may engage if the

rear wheels are spinning fast enough.

Remove the five lug nuts and the wheel. Place new wheel

on the axle hub and secure with nuts.

Tighten nuts diagonally until snug.

Remove support stands and lower vehicle.

Finish tightening the nuts to 65-75 lb-ft using a torque

wrench.

Figure 7-3

Changing Brake Pads

WARNING: Using an unstable lifting device and

vehicle support may result in bodily injury. Use a

safe lifting device and supports to work on raised

vehicle.

To gain access to the brake pads, remove the wheel as described

in the Wheel Section. If less than .030” of material remains on the

pad, replace.

NOTE: Brake pads must be replaced as a set, ie., right rear and

left rear.

To change the brake pads, follow the steps below and refer to

Fig. 7-4.

Remove clips at the end of the mounting bolts.

Remove mounting bolts securing caliper and brake pads to

mounting bracket.

Remove brake pads from caliper and replace with new

pads.

Press in brake piston and place caliper and new brake pads

into place in the mounting bracket, making sure brake disc

is between the two brake pads.

IMPORTANT: When pressing in brake piston, take care not

to damage rubber piston seal.

Secure caliper and brake pads to mounting bracket with

mounting bolts and clips removed earlier. Torque the

mounting bolts to 32 to 36 ft. lbs.

Replace wheel as described in Wheel section.

Drive Belt

IMPORTANT: Several components must be removed in order

to change the vehicle’s drive belt. See your Cub Cadet Dealer to

have your drive belt replaced.

Figure 7-4

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Cub Cadet M467 Operator's Manual Page 19

Comments to this Manuals

Related products and manuals for Cars Cub Cadet M467