Cub Cadet CC310 Operator's Manual download pdf (Page 7)

OPERATING THE COUPLER

The coupler enables the use of various optional attachments.

NOTE: To make installing or removing the attachment easier, place

the unit on the ground or on a work bench.

Installing the Attachment

NOTE: Remove the protective cap and gray spacer from the upper

and lower shafts prior to assembling the attachment.

1. Turn the knob counterclockwise to loosen the coupler (Fig. 2).

2. Pull the locking pin out and turn it 90 degrees (Fig. 3), either

clockwise or counterclockwise.

3. While firmly holding the attachment, push it straight into the

coupler.

4. Lock the attachment into the coupler:

a. If the attachment has a release button (Fig. 3), snap it into the

primary hole (Fig. 2), unless noted otherwise in the operator’s

manual for the attachment.

NOTE: Aligning the release button with the guide recess will help

installation (Fig. 2).

b. If the attachment does not have a release button, align the

hole on the attachment with the locking pin. Turn the locking pin

until it retracts into the coupler and snaps into the hole on the

attachment.

5. Turn the knob clockwise to tighten the coupler.

NOTE: Do not tighten the nut (Fig. 4).

For decorative edging with most string trimmer attachments, lock

the release button into the 90° edging hole (Fig. 3).

Removing the Attachment

1. Turn the knob counterclockwise to loosen the coupler (Fig. 2).

2. Unlock the attachment from the coupler:

a. If the attachment has a release button, press and hold the

release button (Fig. 3).

b. If the attachment does not have a release button, pull the

locking pin out and turn it 90 degrees (Fig. 3), either clockwise or

counterclockwise.

3. While firmly holding the upper shaft housing, pull the attachment

straight out of the coupler.

WARNING:

Before using any attachment, read and

understand the manual that came with the attachment.

Follow all safety information contained within.

CAUTION:

Before operating the unit, make sure the

release button or locking pin is fully snapped into the

appropriate hole and the knob is securely tightened.

WARNING:

To avoid serious personal injury and

damage to the unit, shut the unit off before removing or

installing an attachment.

WARNING:

Unless noted otherwise in the operator’s

manual for the attachment, only use the 90˚ edging hole for

decorative trimming with string trimmer attachments.

Using this hole with other attachments could lead to

personal injury or damage to the unit.

Fig. 4

Nut

Fig. 3

90˚ Edging Hole

Locking Pin

Fig. 2

Knob

Primary Hole

Guide Recess

Release Button

Coupler

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments

Cub Cadet CC310 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Grass trimmers Cub Cadet CC310