Cub Cadet CC310 Operator's Manual download pdf (Page 6)

ASSEMBLY

Fig. 1

Bolt

Shaft Grip

Minimum 6 in.

(15.24 cm)

Handle

Shaft

Housing

INSTALLING AND ADJUSTING THE HANDLE

Installing the Handle

1. Push the handle down onto the shaft housing (Fig. 1). The bolt

hole in the handle should be to the right.

2. Insert the bolt into the bolt hole and push it through (Fig. 1).

Tighten the bolt with a 3/ 8” socket, but do not tighten the bolt

completely .

3. While holding the unit in the operating position, move the handle

to the location that provides the best grip. Place it a minimum of

6 inches (15.24 cm) from the end of the shaft grip (Fig. 1).

4. Tighten the bolt with a 3/ 8” socket until the handle is secure.

Adjusting the Handle

If the handle requires adjustment:

1. Loosen the bolt with a 3/ 8” socket (Fig. 1).

2. While holding the unit in the operating position, move the handle

to the location that provides the best grip. Place it a minimum of

6 inches (15.24 cm) from the end of the shaft grip (Fig. 1).

3. Tighten the bolt with a 3/ 8” socket until the handle is secure.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Cub Cadet CC310 Operator's Manual Page 6