Cub Cadet 526 SWE Operator's Manual download pdf (Page 9)

Insert the hex rod into the pinion gear below the joystick. 6.

Make sure to line up the hole in the hex rod with the arrow

on the pinion gear. See Fig. 3-8.

NOTE: The hex rod will fit snuggly into the pinion gear.

Support the rear of the dash panel with one hand while

inserting the hex rod with your other hand to ensure the

hex rod is inserted all the way into the pinion gear.

NOTE: The hole is a reference for aligning the rod with the

indicator arrow on the pinion gear, and will be visible after

the rod has been inserted.

Push the hex rod toward the control panel until the hole 7.

in the hex rod lines up with the hole in the chute control

input closest to the chute control head and insert the

cotter pin. See Fig. 3-9.

NOTE: The second hole is used to achieve further

engagement of the hex rod into the pinion gear if required.

Refer to page 18 for Chute Control Rod adjustments.

Figure 3-8

Finish securing chute control head to chute support 8.

bracket with wing nut, clevis pin, and bow-tie cotter pin

removed in step 1. See Fig. 3-3.

Check that all cables are properly routed through the cable 9.

guide on top of the engine. See Fig. 3-10.

NOTE: For smoothest operation, the cables should all be to

the left of the hex rod.

NOTE: Models with 2-Way Chute Control have only one

cable to route through the cable guide.

Set-Up

Shear Pins

A pair of replacement auger shear pins and bow tie cotter pins

are included with your snow thrower. Store them in your snow

thrower’s dash panel until needed. See Fig. 3-11.

Figure 3-9

Figure 3-10

Figure 3-11

9se c t i O n 3 — as s e M b l y & se t -up

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Cub Cadet 526 SWE Operator's Manual Page 9