Cub Cadet 526 SWE Operator's Manual download pdf (Page 23)

Troubleshooting

Problem Cause Remedy

Engine fails to start Choke not in CHOKE position.1.

Spark plug wire disconnected.2.

Fuel tank empty or stale fuel.3.

Engine not primed. 4.

Faulty spark plug.5.

Key not in ignition on engine.6.

Move choke to CHOKE position.1.

Connect wire to spark plug.2.

Fill tank with clean, fresh gasoline.3.

Prime engine as instructed in the Engine 4.

Operator’s Manual.

Clean, adjust gap, or replace.5.

Insert key fully into the switch.6.

Engine running erratically/

inconsistent RPM (hunting

or surging)

Engine running on CHOKE.1.

Stale fuel.2.

Water or dirt in fuel system.3.

Carburetor out of adjustment.4.

Engine over-governed5.

Move choke lever to RUN position.1.

Fill tank with clean, fresh gasoline.2.

Drain fuel tank. Refill with fresh fuel.3.

Contact an authorized Service Center.4.

Contact an authorized Service Center.5.

Engine overheats Carburetor not adjusted properly.1. Contact an authorized Service Center.1.

Excessive vibration Loose parts or damaged auger.1. Stop engine immediately and disconnect spark 1.

plug wire. Tighten all bolts and nuts. If vibration

continues, have unit serviced by an authorized

Service Center.

Loss of power Spark plug wire loose.1.

Gas cap vent hole plugged.2.

Connect and tighten spark plug wire.1.

Remove ice and snow from gas cap. Be certain 2.

vent hole is clear.

Unit fails to propel itself Drive control cable in need of adjustment. 1.

Drive belt loose or damaged.2.

Friction wheel worn.3.

Adjust drive control cable. Refer to Maintenance 1.

& Adjustments section.

Replace drive belt. Refer to Service section2.

Replace friction wheel. Refer to Service section.3.

Unit fails to discharge snow Chute assembly clogged. 1.

Foreign object lodged in auger. 2.

Auger control cable in need of 3.

adjustment.

Auger belt loose or damaged.4.

Shear pin(s) sheared.5.

Stop engine immediately and disconnect spark 1.

plug wire. Clean chute assembly and inside of

auger housing with clean-out tool or a stick.

Stop engine immediately and disconnect spark 2.

plug wire. Remove object from auger with clean-

out tool or a stick.

Refer to Auger Control Test. 3.

Refer to Maintenance & Adjustments section.4.

Replace with new shear pin(s).5.

Engine fails to start Extension cord not connected (when 1.

using electric start button, on models so

equipped)

Connect one end of the extension cord to the 1.

electric starter outlet and the other end to a

three-prong 120-volt, grounded, AC outlet.

Chute fails to easily rotate

180 degrees

Chute assembled incorrectly.1. Unassemble chute control and reassemble as 1.

directed in the Assembly section.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Cub Cadet 526 SWE Operator's Manual Page 23

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 526 SWE