Cub Cadet 526 SWE Operator's Manual download pdf (Page 10)

Chute Clean-Out Tool

The chute clean-out tool is fastened to the top of the auger

housing with a mounting clip and a cable tie at the factory. Cut

the cable tie before operating the snow thrower. See Fig. 3-12.

Tire Pressure

WARNING: Under any circumstance do not exceed

manufacturer’s recommended psi. Equal tire

pressure should be maintained at all times. Excessive

pressure when seating beads may cause tire/rim

assembly to burst with force sufficient to cause

serious injury. Refer to sidewall of tire for

recommended pressure.

The tires are over-inflated for shipping purposes. Check the tire

pressure before operating the snow thrower. Refer to the tire side

wall for tire manufacturer’s recommended psi and deflate (or

inflate) the tires as necessary.

NOTE: Equal tire pressure is to be maintained at all times for

performance purposes.

Adjustments

Skid Shoes

The snow thrower skid shoes are adjusted upward at the factory

for shipping purposes. Adjust them downward, if desired, prior

to operating the snow thrower.

CAUTION: It is not recommended that you operate

this snow thrower on gravel as it can easily pick up and

throw loose gravel, causing personal injury or damage

to the snow thrower and surrounding property.

For close snow removal on a smooth surface, raise skid •

shoes higher on the auger housing.

Use a middle or lower position when the area to be cleared •

is uneven, such as a gravel driveway

NOTE: If you choose to operate the snow thrower on a gravel

surface, keep the skid shoes in position for maximum clearance

between the ground and the shave plate.

To adjust the skid shoes:

Loosen the four hex nuts (two on each side) and carriage 1.

bolts. Move skid shoes to desired position. See Fig. 3-13.

Make certain the entire bottom surface of skid shoe is 2.

against the ground to avoid uneven wear on the skid shoes.

Retighten nuts and bolts securely.3.

Figure 3-13

Chute Clean-out Tool

Figure 3-12

10 se c t i O n 3— as s e M b l y & se t -up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Cub Cadet 526 SWE Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 526 SWE