Cub Cadet 526 SWE Operator's Manual download pdf (Page 21)

21se c t i O n 7 — se r v i c e

Back out the stop bolt to increase the clearance between 6.

the friction wheel disc and friction wheel. See Fig. 7-7.

Slip the drive belt off the pulley and between friction 7.

wheel and friction wheel disc. See Fig. 7-7.

Remove and replace belt in the reverse order.8.

Friction Wheel Inspection

(524 SWE, 526 SWE, 528 SWE & 528 SW)

If the snow thrower fails to drive with the drive control engaged,

and performing the drive control cable adjustment fails to

correct the problem, the friction wheel may need to be replaced.

NOTE: Special tools are required and several components must

be removed and in order to replace the snow thrower’s friction

wheel rubber. See your authorized service dealer to have the

friction wheel rubber replaced or phone Customer Support

as instructed on page 2 for information on ordering a Service

Manual.

To inspect the friction wheel, proceed as follows:

Allow the engine to run until it is out of fuel. Do not 1.

attempt to pour fuel from the engine.

Carefully pivot the snow thrower up and forward so that it 2.

rests on the auger housing.

Remove the frame cover from the underside of the snow 3.

thrower by removing four self-tapping screws which secure

it. See Fig. 7-8.

Examine the friction wheel for signs of wear or cracking.4.

Friction Wheel Removal

(524 WE)

If the snow thrower fails to drive with the drive control engaged,

and performing the drive control cable adjustment fails to

correct the problem, the friction wheel may need to be replaced.

Follow the instructions below. Examine the friction wheel for

signs of wear or cracking and replace if necessary:

Allow the engine to run until it is out of fuel. Do not 1.

attempt to pour fuel from the engine.

Place the shift lever in third Forward (F3) position.2.

Carefully pivot the snow thrower up and forward so that it 3.

rests on the auger housing.

Remove the frame cover from the underside of the snow 4.

thrower by removing the self-tapping screws which secure

it. Remove the right-hand wheel by removing the screw

and bell washer which secure it to the axle. See Fig. 7-8.

Stop Bolt

Figure 7-7

Figure 7-8

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Cub Cadet 526 SWE Operator's Manual Page 21

Comments to this Manuals

Related products and manuals for Snow throwers Cub Cadet 526 SWE