Cub Cadet 524 SWE Operator's Manual download pdf (Page 9)

Push the rod toward the control panel until the hole in the 8.

hex rod lines up with the hole in the chute control input

closest to the chute control head and insert the cotter pin.

See Fig. 3-8.

Note: The second hole is used to achieve further

engagement of the hex rod into the pinion gear if required.

Refer to page 19 for Chute Control Rod adjustments.

Check that all cables are properly routed through the cable 9.

guide on top of the engine. See Fig. 3-9.

Note: For smoothest operation, the cables should all be to

the left of the hex rod.

Set-Up

Shear Pins

A pair of replacement auger shear pins and bow tie cotter pins

are included with your snow thrower. Store them in your snow

thrower’s dash panel until needed. See Fig. 3-10.

Chute Clean-Out Tool

The chute clean-out tool is fastened to the top of the auger

housing with a mounting clip and a cable tie at the factory. Cut

the cable tie before operating the snow thrower. See Fig. 3-11.

Figure 3-8

Figure 3-9

Figure 3-10

Chute Clean-out Tool

Figure 3-11

9se c t i O n 3 — as s e M b l y & se t -up

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Cub Cadet 524 SWE Operator's Manual Page 9