Cub Cadet 524 SWE Operator's Manual download pdf (Page 24)

Back out the stop bolt to increase the clearance between 6.

the friction wheel disc and friction wheel. See Fig. 8-7.

Slip the drive belt off the pulley and between friction 7.

wheel and friction wheel disc. See Fig. 8-7.

Remove and replace belt in the reverse order.8.

NOTE: Engaging the drive control will ease reassembly of

the belt.

Friction Wheel Inspection

If the snow thrower fails to drive with the drive control engaged,

and performing the drive control cable adjustment fails to

correct the problem, the friction wheel may need to be replaced.

NOTE: Special tools are required and several components must

be removed and in order to replace the snow thrower’s friction

wheel rubber. See your local Cub Cadet Dealer to have the

friction wheel rubber replaced or phone Customer Support

as instructed on page 2 for information on ordering a Service

Manual.

To inspect the friction wheel, proceed as follows:

Allow the engine to run until it is out of fuel. Do not 1.

attempt to pour fuel from the engine.

Carefully pivot the snow thrower up and forward so that it 2.

rests on the auger housing.

Remove the frame cover from the underside of the snow 3.

thrower by removing four self-tapping screws which secure

it. See Fig. 8-8.

Examine the friction wheel for signs of wear or cracking. 4.

See Fig. 8-9.

Stop Bolt

Figure 8-7

Figure 8-8

Figure 8-9

24 se c t i O n 8— se r v i c e

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Cub Cadet 524 SWE Operator's Manual Page 24