Cub Cadet CC350 Operator's Manual download pdf (Page 7)

Figure 3-5

CUTTING HEIGHT

Step 5

All wheels must be

placed in the same

relative position.

GRASS CATCHER

Step 6

Make certain bag is

turned right side out

before assembling

(warning label will be

on the outside).

Setup and

Adjustment

Figure 3-6

Figure 3-7

Never operate mower

unless the hooks on

the grass catcher are

firmly seated in the

slots on the handle

bracket assemblies,

and the rear dis-

charge door rests

firmly against top of

the grass catcher.

6. Follow steps below to assemble the grass catcher:

a. Place bag over frame so that its black plastic side

is at the bottom. See Figure 3-5.

b. Slip plastic channel of grass bag over hooks on the

frame. All the plastic channels except center top of

bag attach from outside of bag.

c. Attach center top of bag from inside of bag.

7. Follow steps below to attach grass catcher:

a. Lift rear discharge door.

b. Place grass catcher on the pivot rod. Let go

of discharge door so that it rests on the grass

catcher. See Figure 3-6.

To remove grass catcher or convert to a mulcher, lift rear

discharge door on the mower as shown in Figure 3-6. Lift

grass catcher up and out of the pivot rod. Release rear

discharge door to allow it to close rear opening of mower.

WARNING: Never operate mower

unless the hooks on the grass catcher

are firmly seated in the slots on the

handle bracket assemblies, and the rear

discharge door rests firmly against top of the grass

catcher.

8. If converting to side discharge, make sure grass

catcher is off unit and rear discharge door is closed.

a. Lift mulching plug on the right side of mower.

b. Slide two hooks of side discharge chute under

the hinge pin on the mulching plug assembly and

lower the side mulching plug. See Figure 3-7.

NOTE: Do not remove the side mulching plug at any time,

even when you are not mulching.

9. The adjustment wheel is located in the drive control

handle housing and is used to tighten or loosen the

drive belt. You will have to adjust the drive control if

any of the following happens:

a. The mower does not propel itself with the drive

control engaged.

b. The mower’s drive wheels hesitate with the drive

control engaged.

If either of these conditions occur, rotate the adjustment

wheel clockwise to tighten and counter-clockwise to

loosen the cable to adjust drive control. See Figure 3-8.

WARNING

Figure 3-8

















1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

Cub Cadet CC350 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Grass trimmers Cub Cadet CC350