Cub-cadet 726 TDE User Manual download pdf (Page 7)

Assembly

Handle

Place the shift lever in the Forward-6 position1.

Remove the lower plastic wing nut and carriage bolt from 2.

each side of the upper handle; then raise the upper handle

assembly until it snaps over the lower handle. See Fig. 3-1.

NOTE: Make certain the cables are seated properly in the

roller guides. See Figure 3-2.

Looking beneath the handle panel, check that all of the 3.

cables (steering, auger, shift, and drive) are properly routed

and not pinched or kinked.

Secure the handle by tightening the plastic knob located 4.

on both the left and right sides of the handle. Remove

and discard any rubber bands, if present. They are for

packaging purposes only.

Chute Assembly

Remove cotter pin, wing nut and hex screw from chute 1.

control head. Remove clevis pin and bow-tie cotter pin

from chute support bracket. See Fig. 3-3.

Figure 3-1

Chute Control Head

Chute

Chute Support

Bracket

Chute Base

Figure 3-3

Figure 3-2

Assembly & Set-Up

Contents of Crate

One Snow Thrower• Two Replacement Auger Shear Pins• One Chute Assembly•

One Snow Thrower Operator’s •

Manual

One Product Registration Card• One Chute Control Rod•

One Engine Manual•

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Cub-cadet 726 TDE User Manual Page 7