Cub-cadet 726 TDE User Manual download pdf (Page 15)

Starting and Stopping the Engine

Refer to the Engine Operator’s Manual packed with your snow

thrower for instructions on starting and stopping the engine.

To Engage Drive

With the throttle control in the Fast (rabbit) position, move 1.

the shift lever into one of the six forward (F) positions or

two reverse (R) positions. Select a speed appropriate for

the snow conditions and a pace you are comfortable with.

Squeeze the drive control against the handle and the snow 2.

thrower will move. Release it and the drive motion will

stop.

To Engage Augers

To engage the augers and start throwing snow, squeeze the

auger control against the left handle. Release to stop the augers.

To Steer

With the drive control engaged, squeeze the right steering

trigger control to turn right. Squeeze the left steering trigger

control to turn left.

Engage Heated Grips

To activate the heated grips, move the switch found on the rear

of the dash panel into the ON position. See Fig. 5-1.

CAUTION: It is recommended that you wear gloves

when using the heated grip. If the heated grip

becomes too hot, turn it off.

Set Track Position

Move the track lock lever to the right, then forward or backward

to one of the three positions. See Fig. 5-2.

NOTE: When positioning the track lock lever into one of the three

operating locations, apply a downward force on the right handle

with your left hand while you shift the track lock lever into the

desired position with your right hand.

Figure 5-1

Track

Lock

Lever

Packed Snow

Transport

Normal Snow

Top View

Figure 5-2

Operation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Cub-cadet 726 TDE User Manual Page 15