Cub Cadet 420A Operator's Manual download pdf (Page 16)

• Run up the jam nut of the rear side until it touches

and then back off one turn.

• Tighten the front side jam nut.

• Check the brake pedal by hand. It should have 3/4”

free travel.

• Hook up the return spring.

• Rotate the rear wheels by hand with brake pedal

released. The wheels should rotate freely.

• Cautiously complete the testing on level ground by

operating the machine and applying brakes in a

normal manner.

• Repeat the adjustment procedure if necessary.

Cleaning

The body panels are scratch and impact resistant

automotive quality ABS plastic. The use of standard car

wash soap and non-abrasive car wax is acceptable for

cleaning the body panels. Avoid any abrasive cleaner

or rubbing compounds for these will damage the body

panels. Dry thoroughly to avoid water spots.

WARNING: Damage may occur if direct hose

spray comes in contact with any other electri-

cal components, i.e. at instrument cluster or

under dash.

Storage

• Stop the vehicle on a level surface and apply

parking brake.

• Allow vehicle to cool.

• Replace all worn, damaged, or missing parts and

tighten loose hardware as needed.

• Wash the vehicle and clean inside the engine

compartment and under the cargo box.

• Run engine for several minutes to dry belts,

pulleys, and other moving parts.

• Clean and polish metal and plastic surfaces.

• Apply light coat of oil to pivot and wear points to

prevent rust.

• Lubricate grease points.

• Replace fuel filter if needed. See engine manual.

• Change engine oil and filter. See engine manual.

• Drain all old fuel from tank.

Prepare fuel system for storage.

If planning to store vehicle with fuel tank empty:

• Add a small quantity of fresh stabilized fuel to tank.

Run engine until it runs out of fuel. This will circulate

fuel mixture through engine.

If planning to store vehicle with fuel in the tank:

• Fill tank completely with fresh stabilized fuel to

prevent condensation build-up. Run engine for

several minutes to circulate fuel mixture through

engine.

• Turn the ignition key to the STOP position and

remove the key.

• Remove and clean battery. See Battery in Service

Section.

• Store battery in a cool, dry place. Fully charge

battery periodically during storage to maintain its

longevity.

• Support vehicle safely on blocks or stands to take

weight off tires. Reduce 1/3 air from tires.

• Cover vehicle with waterproof cover if stored

outside.

SECTION 5: SERVICE CHART

Before

Each

Use

First

10 Hours

Every

50 Hours

Every

100 Hours

Every

500 Hrs

or 2 years

Check Transaxle Oil

Change Transaxle Oil #

Tighten Wheel Bolts

Check Drive Belt

Grease Front Steering Spindle

Check Interlock Switch System

Replace Interlock Switch

# Change at the first 50 hours then again at 500 hours.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Cub Cadet 420A Operator's Manual Page 16

Comments to this Manuals

Related products and manuals for Tractor Cub Cadet 420A