Cub Cadet 420A Operator's Manual download pdf (Page 14)

Charging

WARNING: Charge battery in a well

ventilated area and keep away from an open

flame or pilot light as on a water heater, space

heater, furnace, clothes dryer or other gas

appliances.

If the vehicle has not been put into use for an extended

period of time, charge the battery with an automotive

type 12-volt charger for a minimum of one hour at six

amps.

Replacing Headlights

Headlights

• Remove the two screws from the each headlight

housing located behind each fender.

• Remove the headlight lens and housing from the

front. The lens and the housing are connected.

See Figure 16.

• Twist the plastic connector and pull out light

assembly.

• Disconnect light bulb assembly from wire connector

and replace with new bulb assembly.

• Reassembly in reverse order.

Figure 16

Replacing Warning Lights

• Raise hood to get access to under the dash panel.

• Remove the appropriate bulb socket and replace

bulb.

• Reattach socket and lower hood. Secure hood to

fender.

Fuses

• Raise hood to get access to under the dash panel.

• Remove the appropriate electrical fuse and replace

with proper amperage fuse. (See schematic under

hood)

• Reattach socket and lower hood. Secure hood to

dash.

Tire Pressure

WARNING: Explosive separation of tire and

rim parts is possible when they are serviced

incorrectly. Do not stand in front or over tire

assembly when inflating.

The recommended operating tire pressure is approxi-

mately 5-7 psi for all tires. Overinflating above

recommended tire pressure can reduce the life of the

tire. Check tire pressure before driving the vehicle.

NOTE: For high loads 8-10 psi is recommended for the

rear tires. The recommended tire pressure while using

the snow plow option is 8-12 psi in the front tires.

Wheel Replacement

WARNING: Using an unstable lifting device

and vehicle support may result in bodily injury.

Use a safe lifting device and supports to work

on raised vehicle.

Rear Wheels

• Stop the vehicle on a level surface and apply

parking brake.

• Turn the ignition key to the STOP position and

remove the key.

• Loosen but do not remove the five wheel bolts from

the axle hub. See Figure 17.

Figure 17

• Raise rear of vehicle with a safe lifting device and

place support stands under vehicle.

• Remove the five wheel bolts and rear wheel. Place

new wheel on the axle hub and secure with bolts.

• Tighten wheel bolts diagonally until snug.

• Remove support stands and lower vehicle.

• Finish tightening the bolts to 55-60 lb-ft using a

torque wrench.

Front Wheels

• Stop the vehicle on a level surface and apply

parking brake.

• Turn the ignition key to the STOP position and

remove the key.

• Loosen 16 x 40 cap screw.

• Raise front of vehicle with a safe lifting device and

place support stands under vehicle.

Headlight Lens

& Housing

Wheel Bolts

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Cub Cadet 420A Operator's Manual Page 14

Comments to this Manuals

Related products and manuals for Tractor Cub Cadet 420A