Cub Cadet GTX 2100 Owner's Manual

1 BERCO Subframe with Electric Lift & Drive Mechanism for CUB CADET LTX, SLTX & GTX TORO 2010 LX & GT & 2010 MTD 900 SERIES CAUTION:

8 NOTE 2: If your tractor has the muffler coming out the front as shown in the drawing, please install the heat shield as shown below. If the muffler

9 ASSEMBLY NOTE: Lift the front part of foot rest to remove tractor bolt (item 1). Install the cab support (item 5). # Item Description Action 3 Fl

10 ASSEMBLY Install the winch control switch STEP 2: INSTALLATION OF THE WINCH CONTROL SWITCH Install the relay (item 1). # Item Description Action 2

11 ASSEMBLY CONNECTING THE WIRES NOTE: The posts on the relay are identified by numbers. (1-2-3-4). Install the wires from the winch on the posts

12 ASSEMBLY CAUTION FOR YOUR SECURITY: Read and follow the safety precautions for the battery in the vehicle’s manual. CONNECT THE WIRES ON THE BATT

13 ASSEMBLY STEP 3: DRIVE MECHANISM INSTALLATION: WARNING TO PREVENT INJURIES: It is the person who installs the drive mechanism responsibility to m

14 ASSEMBLY For tractors with Manual Clutch activated by a cable: Install the tractor’s manual clutch cable . * Remove the spring. # Item Description

15 ASSEMBLY If applicable, you can remove or add a flat washer (item 1) on the tension pulley (item 2) for a better adjustment. Engage and disengag

16 OPERATION & MAINTENANCE CAUTION Read the vehicle Owner’s Manual carefully. Be thoroughly familiar with the controls & proper use of the a

17 TROUBLESHOOTING PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION Winch runs backwards. Winch wires reversed. Recheck wiring. Switch wires reversed. R

2 LIMITED WARRANTY Bercomac Limitée 92, Fortin North, Adstock, Quebec, Canada, G0N 1S0 Conditions and Products Covered: BERCOMAC guarantees any part

18 PARTS BREAKDOWN COMPACT DRIVE MECHANISM 700528-1

19 O/L = Obtain Locally PARTS LIST COMPACT DRIVE MECHANISM 700528-1 Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 1 D

20 PARTS BREAKDOWN NORTHEAST DRIVE MECHANISM 700529-1

21 PARTS LIST NORTHEAST DRIVE MECHANISM 700529-1 Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 1 Drive frame Châssis

22 PARTS BREAKDOWN SUBFRAME 700527-2

23 PARTS LIST SUBFRAME 700527-2 Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 1 Left support Support gauche 1 1055

24 PARTS LIST SUBFRAME 700527-2 Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 27 Winch control switch Commutateur de

25 PARTS BREAKDOWN WINCH 106125 PARTS LIST WINCH 106125 Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 1 Reduction box

26 TORQUE SPECIFICATION TABLE GENERAL TORQUE SPECIFICATION TABLEUSE THE FOLLOWING TORQUES WHEN SPECIAL TORQUES ARE NOT GIVEN NOTE: These values ap

27 ATTACHMENTS ATTACHMENTS ROTARY BROOM #700380 with nylon brush #700381 with polypropylene brush. Fits on same subframe as snowblower & utility

1 TABLE OF CONTENTS INTRODUCTION ...

28 NOTES ____________________________________________________________________________________________________________________________________________

29 NOTES ____________________________________________________________________________________________________________________________________________

30 WHEN PERFORMANCE & DEPENDABILITY ARE NON NEGOTIABLE ! Bercomac Limitée 92, Fortin North, Adstock, Quebec, Canada, G

2 INTRODUCTION TO THE PURCHASER This new accessory was carefully designed to give years of dependable service. This manual has been provided toassi

3 SAFETY PRECAUTIONS Careful operation is your best insurance against an accident. Read this section carefully before operating the vehicle and acces

4 OPERATION: 1. Do not put hands or feet near, under or inside rotating parts. 2. Exercise extreme caution when operating on or crossing gravel

5 SAFETY DECALS REPLACE IF DECALS ARE DAMAGED SEE PARTS BREAKDOWN FOR DECAL LOCATION DECAL #105133 Failure to observe these instructions could lead to

6 ASSEMBLY Install the left & right supports (item 2) on each side of the vehicle. Item # Description Action 1 Tractor shoulder screw Remove f

7 ASSEMBLY NOTE: Remove tractor bolt (A) from under the foot rest pad as shown. Remove tractor bolt (B) from underneath the foot rest. Keep the bolts