Cub Cadet CC 550 SP Operator's Manual download pdf (Page 17)

17se c t i O n 7 — se r v i c e

Working from the rear of the mower, carefully c.

remove belt from transmission pulley. See Fig. 7-3.

Once belt is off transmission pulley, push down on d.

deck baffle to access engine pulley and slide belt off

this pulley and out from under the deck. See Fig. 7-3.

5. Replace with new belt, working it between the deck and

baffle, first around the transmission pulley and then the

engine pulley.

NOTE: Make certain that belt is seated correctly and that it

is riding smoothly on the engine pulley and is not pinched

between the lower and upper pulley halves.

6. Tighten self-tapping screw securing deck baffle loosened

earlier.

7. Replace engine baffle and secure with self tapping screws.

8. Replace blade, blade adapter, and associated hardware.

Follow instructions in Blade Care section for proper

assembly.

9. Tip mower back onto its wheels and remove piece of

plastic from under gas cap (if applicable).

Figure 7-3

Off-Season Storage

The following steps should be taken to prepare your lawn mower

for storage.

Clean and lubricate mower thoroughly as described in the •

lubrication instructions.

Do not use a pressure washer or garden hose to clean your •

unit.

Coat mower’s cutting blade with chassis grease to prevent •

rusting.

Store mower in a dry, clean area. Do not store next to •

corrosive materials, such as fertilizer.

When storing any type of power equipment in a poorly

ventilated or metal storage shed, care should be taken to

rust-proof the equipment. Using a light oil or silicone, coat the

equipment, especially cables and all moving parts of your lawn

mower before storage.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Cub Cadet CC 550 SP Operator's Manual Page 17