Cub-cadet 933 SWE User Manual download pdf (Page 18)

• Remove the four hex tapp screws securing the

friction wheel to the bearing/extrusion plate

assembly. See Figure 25.

• With its recessed face toward the extrusion plate,

position the new friction wheel so that its four screw

holes align with the extrusion plate holes; then push

the friction wheel onto the hub of the bearing/

extrusion plate assembly. See Figure 25.

• Secure the friction wheel with the four hex tap

screws. Torque the screws to 6-9 ft-lbs.

Figure 25

• Insert the pin from the shift arm assembly into the

friction wheel assembly. Hold the assembly in

position and slide the hex shaft through the right

side of the assembly hub. Refer to Figure 24.

• Slide the hex hub of the sprocket onto the left end

of the hex shaft. Slide the spacer onto the shaft.

See Figure 26.

Figure 26

• After making certain the chain is properly

positioned around the sprocket, push the hex shaft

fully through the frame and into the bearing in the

left side of the frame housing.

• Secure the hex shaft with the belleville washer and

hex bolt removed earlier.

• Install the frame cover and secure with the six self-

tapping screws. Do not overtighten the tapping

screws.

• Lower the snow thrower to its normal operating

position.

NOTE: If you placed plastic film under the gas cap, be

certain to remove it.

SECTION 8: OFF-SEASON STORAGE

WARNING: Never store engine with fuel in

tank indoors or in poorly ventilated areas,

where fuel fumes may reach an open flame,

spark or pilot light as on a furnace, water

heater, clothes dryer or other gas appliance.

• If unit is to be stored over 30 days, prepare engine

for storage as instructed in the engine manual.

• Remove all debris from the exterior of equipment.

• Follow lubrication recommendations on page 13.

• Always store the snow thrower in a clean, dry area.

NOTE: When storing any type of power equipment in

an unventilated or metal storage shed, care should be

taken to rust proof the equipment. Using a light oil or

silicone, coat the equipment, especially any chains,

springs, bearings and cables.

Friction Wheel

Bearing/Extrusion

Plate Assembly

Hex Tapp

Screws

Sprocket

Hex Hub

of Sprocket

Spacer

Hex

Shaft

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

Cub-cadet 933 SWE User Manual Page 18

Comments to this Manuals

Related products and manuals for Cars Cub-cadet 933 SWE