Cub-cadet 933 SWE User Manual download pdf (Page 11)

Chute Clean-Out Tool

The chute clean-out tool is conveniently fastened to the

rear of the auger housing with a mounting clip. Never

use your hand to clean a clogged chute or chute

opening; use this clean-out tool instead.

• Release both the wheel drive control and the auger

drive control levers

• Stop the engine by removing the ignition key.

• Remove the chute clean-out tool from the clip

which secures it to the rear of the auger housing.

See Figure 10.

• Use the shovel-shaped end of the clean-out tool to

remove any snow and ice in the discharge chute.

• Re-fasten the clean-out tool to the mounting clip on

the rear of the auger housing and restart engine.

• While standing in the operator’s position (behind

the snow thrower), engage the auger clutch lever

for a few seconds to clear any remaining snow or

ice from the discharge chute before continuing to

clear snow.

Figure 10

SECTION 5: MAKING ADJUSTMENTS

WARNING: NEVER attempt to clean chute

or make any adjustments while engine is

running.

Shift Rod

If you are unable to shift into all six forward positions or

the two reverse positions, it may be necessary to adjust

the shift rod. Adjust the shift rod as follows:

• From beneath the handle panel, note the hole

location and direction of insertion of the shift rod

ferrule in the shift lever. The ferrule is normally

inserted into the lower/rear hole of the shift lever

from the right side.

• Remove the internal cotter pin and flat washer from

the ferrule and withdraw the ferrule from the shift

lever. Refer to Figure 11.

• Place shift lever in the sixth (6) position or fastest

forward speed.

• Push shift arm assembly down as far as it will go.

• As necessary, rotate the ferrule up or down the shift

rod until the ferrule aligns with the lower/rear hole of

the shift lever. Refer to Figure 11.

• Insert the ferrule into the lower/rear hole from the

right side of the shift lever.

• Reinstall the washer and the internal cotter pin.

Figure 11

IMPORTANT:

Before operating the snow thrower, make

sure the wheel drive control cable is correctly adjusted

according to instructions beginning on page 6.

NOTE: For adjustment of the auger control, refer to

Final Assembly Adjustments in Section 2.

Chute Clean-Out Tool

Clip

Shift Lever

Ferrule

Shift Arm

Lower

Clutch Rod

Upper

Connector

Internal

Flat

Washer

Cotter Pin

Shift Rod

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments

Cub-cadet 933 SWE User Manual Page 11

Comments to this Manuals

Related products and manuals for Cars Cub-cadet 933 SWE