Cub-cadet 933 SWE User Manual download pdf (Page 12)

Wheel Drive Control

If you are uncertain about correct adjustment, proceed

as follows:

• Drain the gasoline out of your snow thrower’s

engine, and place a piece of plastic film under the

gas cap to avoid spillage.

• Tip the snow thrower forward, allowing it to rest on

the auger housing.

• Remove the frame cover underneath the snow

thrower by removing six self-tapping screws.

• Locate the opening between the axle support

bracket and the front frame support (See Figure

12). Looking through the opening, perform the

following checks and adjust as necessary:

a. With the wheel drive control released, check if

there is clearance between friction wheel and

drive plate in all positions of the shift lever. See

Figure 12.

b. With the wheel drive lever engaged, check if the

friction wheel solidly contacts the drive plate.

See Figure 12.

c. If there is no friction wheel clearance, or the

friction wheel does not solidly contact the drive

plate, re-adjust the lock nut on the lower end of

the wheel drive cable following the instructions

on page 7.

• Reassemble the frame cover.

• If you placed plastic film under the gas cap earlier,

remove it now.

Figure 12

Auger Control

Refer to instructions for adjusting the auger control on

page 7. Make certain to check for correct adjustment

as instructed before operating the snow thrower.

Chute Assembly

The distance snow is thrown can be adjusted by

adjusting the angle of the chute assembly. Refer to

page 9 for instructions.

The remote chute control cables have been pre-

adjusted at the factory. Move the remote chute lever on

the control panel back and forward to adjust angle of

the chute assembly.

Skid Shoe

The space between the shave plate and the ground can

be adjusted by raising or lowering the skid shoes.

For close snow removal on a smooth surface such as a

concrete or asphalt driveway, place the skid shoes in

the low position.

Adjust the skid shoes to the middle or high position

when the area to be cleared is uneven.

When operating on gravel or stone driveways, always

put skid shoes in the high position.

Adjust skid shoes as follows (Refer to Figure 13):

• Loosen, but do not remove, the three hex lock nuts

which fasten the skid shoe to the auger housing.

• Raise or lower the skid shoe as needed to place the

shave plate in the desired position above the

ground.

• Retighten the hex lock nuts loosened earlier.

• As close as possible, adjust the skid shoe on the

other side into the same position on the auger

housing .

Figure 13

NOTE: Make certain the bottom surface of skid shoe is

flat against the ground to avoid uneven wear

Trigger Cables

Shift Arm

Drive Actuator

Auger

Hex Screw &

Hex Drive

Drive

Rubber

Actuator

Bracket

Belleville

Washer

Friction

Wheel

Bracket

Shaft

Plate

Axle Support

Brkt. Opening

High

Hex Nuts

Skid

Low

Shave

Shoes

Carriage

Plate

Bolts

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Cub-cadet 933 SWE User Manual Page 12

Comments to this Manuals

Related products and manuals for Cars Cub-cadet 933 SWE