Cub Cadet EX2900 Operator's Manual download pdf (Page 120)

15-4

15. SERVICING THE ELECTRICAL SYSTEM

Ex2900 / 3200 Operator's Manual

2. Installing the Battery

1. Install the battery onto the tractor.

2. Inspect the battery vent to be sure that the vent holes

are open.

3. Connect the positive (+) cable to the battery first, and

then the negative (–) cable.

4. Apply petroleum jelly to the battery terminals to protect

them against corrosion.

5. Install the battery hold-down assembly. Avoid over-

tightening.

6. Lower the hood.

■ Cleaning the Battery and Terminals

1. Disconnect the battery cables, negative (–) cable first,

and remove the battery.

2. Dissolve four tablespoons of baking soda in 1 gallon of

water to prepare a solution. Use this solution to wash

the battery. Be very careful not to allow the solution to

enter the battery cells.

3. Rinse the battery with water and allow it to dry.

4. Clean the terminals and battery cable ends with wire

brush to remove corrosion.

5. Apply petroleum jelly or silicone spray to the battery

terminals to protect them against corrosion.

6. Install the battery.

7. Connect the positive (+) cable first, then connect the

negative (–) cable.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 133 134

No comments

Cub Cadet EX2900 Operator's Manual Page 120