Cub Cadet 5234D Operator's Manual download pdf (Page 20)

Hazard Lights

Always use the flashing amber hazard lights along

with the SMV (Slow Moving Vehicle) emblem when

operating the tractor on, or near, roadways. Also

activate the hazard lights when necessary to warn

others that the tractor is being operated in the area.

• To turn on the flashing hazard lights, depress

the top end of the hazard light switch located to

the left of the headlight switch.

• To turn off the hazard lights, depress the

bottom of the light switch.

USING THE TOP LINK RETAINER HOOK

The top link hook is provided to retain the top link of

the three point hitch when not in use.

To utilize the top link hook, proceed as follows:

• Raise the 3-pt. hitch top link fully upward.

• Pivot the link hook from its storage position to

the center and lower the top link into the hook

of the rod. See Figure 20.

IMPORTANT: When using the three point hitch, the

retainer hook must be pivoted fully rearward to

avoid interference with the top link.

Figure 20

REMOVING THE REAR PTO COVER

The rear PTO cover is a safety feature designed to

prevent items from accidentally being caught by the

rotating shaft. The cover should be removed only

when the rear PTO is being utilized.

To remove and reinstall cover, proceed as follows:

• Loosen the two screws on the left side of the

cover. Refer to Figure 21.

• Slide the cover to the right until the slots of the

cover are free of the screws and pull the cover

off. Refer to Figure 21.

• When finished using the rear PTO, slide the

cover fully onto the shaft; then slide the cover

to the left until the slots are underneath the

screw heads. Tighten the screws to secure the

cover. Refer to Figure 21.

Figure 21

USING THE THREE POINT HITCH

WARNING: Always disengage the PTO,

stop the engine, and set the parking

brake before dismounting the tractor

to connect, disconnect, or adjust three

point hitch mounted implements.

Use the rear three point hitch system to attach

three point mounted implements, which are

normally driven by the rear PTO. Use the tractor’s

hydraulic lift system to raise and lower the three

point hitch and set the height position of the

implement.

Refer to the ADJUSTMENTS section for instruc-

tions on adjusting the RH adjustable lift link, top

hitch link, and hitch chains. See Figure 22.

Figure 22

Comments to this Manuals

No comments

Cub Cadet 5234D Operator's Manual Page 20

Comments to this Manuals