Cub Cadet 5234D Operator's Manual download pdf (Page 31)

Accessing the Fuse Center

The fuse center is located on the inside right of the

dash panel. To access the fuse center, remove the

dash panel insert by removing the two screws. See

Figure 37.

To cover the fuse center, reposition the dash panel

insert in the dash and secure with the two screws.

Figure 37

Instrument Panel Fuses

The instrument panel’s circuitry is protected by the

two fuses in the fuse center. If the instrument panel

does not function properly, check the fuses.

• Pull the fuses from the fuse center and check

their condition. Replace a blown fuse with the

same capacity fuse (3 Amp). See Figure 38.

Relays

The PTO relay and starter relay, located in the fuse

center, maintain power to each of those circuits. If

one of the circuits is not functioning properly, have

your dealer electrically check the relay. See Figure

38.

Figure 38

Main Fuse

The main fuse in the tractor wire harness protects

the tractor’s entire electrical system. A blown main

fuse will prevent battery current from passing

though the harness.

To replace the main fuse:

• Raise tractor hood and remove right side panel.

• Locate the fuse holder on the front of the bulk-

head, just inside the right side of the dash panel.

See Figure 39.

Figure 39

• Pull the main fuse from the fuse holder and

replace with the same capacity fuse (30 Amp).

NEVER use a higher amperage fuse.

• Install side panel and lower tractor hood.

Hazard Light Flasher Relay

The flasher relay controls the on/off flashing of the

hazard lights. If the hazard lights do not function

properly, the flasher relay is probably faulty.

Replace the relay as follows:

• Remove the dash panel insert by removing the

two screws. Refer to Figure 37.

• Pull the wire harness from the dash opening.

Cut and remove the electrical tape holding the

flasher relay to the harness. See Figure 40

• Note the position of the two harness leads; then

disconnect the leads from the faulty relay and

connect to the new relay.

• Secure the relay to the wire harness with

electrical tape. Reposition the wire harness in

the dash panel and reinstall the dash insert.

Figure 40

SCREWS

DASH

PANEL

INSERT

FUSE

CENTER

PTO RELAY

INSTRUMENT

PANEL FUSES

(3 AMP)

STARTER

RELAY

DASH

PANEL

MAIN FUSE

FUSE HOLDER

GLOW

PLUG

RELAY

BULKHEAD

FLASHER

RELAY

TAPE

WIRE

HARNESS

LEADS

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Comments to this Manuals

No comments

Cub Cadet 5234D Operator's Manual Page 31

Comments to this Manuals