Cub Cadet 221 HP Operator's Manual download pdf (Page 8)

8 Section 3— ASSembly & Set-Up

Installing the Chute

1. On the 221 HP model place the chute handle on the lower

chute as shown in Figure 3-4. Skip to step 2 for 221 LHP

models. Be certain that the handle is aligned in the channel

on the chute and the tabs snap into place.

Channel

Tab

Figure 3-4

2. Remove the hex washer screws in the chute base. See

Figure 3-5.

Hex Washer

Screw

Figure 3-5

2. Pivot the upper handle into the operating position. Be sure

not to pinch any of the cables in the process. See Figure 3-2.

Wing

Knob

Wing

Knob

Carriage Bolts

Figure 3-2

3. On model 221 HP, tighten the previously removed

hardware to secure the handle in place. See Figure 3-2. On

model 221 LHP proceed with step 4.

4. The handle on model 221 LHP can be set in three different

position. Place the handle in the desired position and then

install wing knobs and carriage bolts in the appropriate

hole and secure the handle. See Figure 3-3.

Carriage

Bolt

Wing

Knob

Figure 3-3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Cub Cadet 221 HP Operator's Manual Page 8