Cub Cadet LTX 1042 KW Operator's Manual download pdf (Page 27)

Figure 7-10

2.

baffle and the cutting blade to act as a stabilizer.



Remove the hex flange nut that secures the blade to the 



To properly sharpen the cutting blades, remove equal 4.

amounts of metal from both ends of the blades along the



angle. Always grind each cutting blade edge equally to



CAUTION: If the cutting edge of the blade has

previously been sharpened, or if any metal

separation is present, replace the blades with new

ones.

WARNING! A poorly balanced blade will cause

excessive vibration, may cause damage to the

tractor and/or result in personal injury.

5.

metal from the heavy side until it balances evenly.

NOTE: When replacing the blade, be sure to install the



a part number stamped in it) facing the ground when the

mower is in the operating position.

CAUTION: Use a torque wrench to tighten the





Battery

CALIFORNIA PROPOSITION 65 WARNING:



contain lead and lead compounds, chemicals known



reproductive harm. Wash hands after handling.

CAUTION: If removing the battery, disconnect the







(Red) wire its terminal first, followed by the



Jump Starting

WARNING! Never jump start a damaged or frozen



ignitions are off. Do not allow cable clamps to touch.

Connect the positive ( +) cable to positive (+) post of your



Connect the other end of the cable to the positive (2. +) post

of the jumper battery.

Connect the negative ( –) cable to the other post of the

jumper battery.

Make the final connection on the engine block of the 4.

tractor, away from the battery. Attach to an unpainted part

to assure a good connection.

CAUTION: If the jumper battery is installed on a



engine when jump starting your tractor.

5.

this manual).

6.

cables, in reverse order of connection.

Figure 7-9

27se c t i O n 7 — se r v i c e

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments

Cub Cadet LTX 1042 KW Operator's Manual Page 27

Comments to this Manuals

Related products and manuals for Lawnmowers Cub Cadet LTX 1042 KW