Cub Cadet 997 Operator's Manual download pdf (Page 7)

SECTION 3: ASSEMBLING YOUR LAWN MOWER

Loose Parts in Carton

1. Grass Bag

2. Grass Bag Adapter

3. Side Discharge Chute

4. Hardware Pack

Hardware Pack

Please identify each piece of the hardware pack as

shown in Figure 1.

Figure 1

NOTE: Reference to right or left side of the mower is

observed from the operating position.

Setting Up Your Lawn Mower

Assembling Handle

• Lift up and pull back on the upper handle to raise

the handle into the operating position. See Figure

2. Make certain the lower handle is seated securely

into the handle bracket assemblies.

Figure 2

• Tighten wing nuts on each side of the handle

making sure that the carriage bolts are seated

properly into the handle. See Figure 2.

• Remove hairpin clip from the outer hole of the weld

pin on each handle brackets. Using a pair of pliers,

squeeze one leg of the lower handle against the

handle bracket. Insert the hairpin clip into the inner

hole on the weld pin. Repeat on the other side. See

Figure 3.

• After moving the hairpin clip, insert the carriage

bolt, from the hardware pack, in the upper hole on

the handle mounting bracket and secure with

plastic wing nut, also from the hardware pack. See

Figure 3. Repeat on the other side.

Figure 3

• Fasten the cable to the lower handle with the two

cable ties found on the lower handle. Pull the cable

ties tight and trim off the excess. See Figure 4.

Figure 4

Carriage Bolt

Wing Nut

Handle Assembly

Handle Mounting

Bracket

Wing Nut

Handle Mounting

Bracket

Lower

Handle

Hairpin

Clip

Inner Hole

Carriage Bolt

Wing Nut

Cable Tie

Lower

Handle

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Cub Cadet 997 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Lawnmowers Cub Cadet 997