Cub Cadet CC4090 Operator's Manual download pdf (Page 23)

Steering Adjustment

If the tractor turns tighter in one direction than the other, or if

the ball joints are being replaced due to damage or wear, the

steering drag links may need to be adjusted.

Adjust the drag links so that equal lengths of each are threaded

into the ball joint on the left side and the ball joint on the right

side:

Remove the hex nut on the top of ball joint. See Fig. 6-6.

Thread the ball joint inward to shorten the drag link. 2.

Thread the ball joint outward to lengthen the drag link.

Replace the hex nut after proper adjustment is achieved.

NOTE: Threading the ball joints too far onto the drag links



between ⁄⁄

Front tire toe-in can be measured as follows:4.

a.

ahead travel.

In front of the axle, measure the distance b.

horizontally from the inside of the left rim to the

inside of the right rim. Note the distance.

Behind the axle, measure the distance horizontally c.

from the inside of the left rim to the inside of the

right rim. Note the distance.

The measurement taken in front of the axle should be 5.

between ⁄⁄

behind the axle.

Hex Nut

Drag Link

Ball Joint

Figure 6-6

23se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

No comments

Cub Cadet CC4090 Operator's Manual Page 23