Cub Cadet CC4090 Operator's Manual download pdf (Page 10)

Attaching the Negative Battery Cable

NOTE: 

negative battery terminal is marked Neg. (–).

The positive cable (heavy red wire) is secured to the positive



The negative cable (heavy black wire) may be secured to



attached, proceed as follows:

Raise the seat and remove the carriage bolt and hex nut 

from the negative cable (heavy black wire).

Remove the black plastic cover, if present, from the 2.

negative battery terminal and attach the negative cable

to the negative battery terminal (–) with the bolt and wing



Make certain the hold-down rod is in position over the 

battery, securing it in place and make certain that the red

rubber boot covers the positive battery terminal to help

protect it from corrosion.

NOTE: If the battery is put into service after the date shown

on top/side of battery, charge the battery as instructed in the

Maintenance section of this manual prior to operating the

tractor.

Checking Tire Pressure

WARNING! Maximum tire pressure under any



maintained at all times.

The tires on your tractor may be over inflated for shipping

purposes. Reduce the tire pressure before operating the tractor.





for maximum p.s.i.

Setting the Deck Gauge Wheels

Move the tractor on a firm and level surface, preferably

pavement, and proceed as follows

Select the height position of the cutting deck by placing 

the deck lift lever in the normally desired mowing height

setting (any of the six different cutting height notches on

the right fender).

Check the gauge wheels for contact or excessive clearance 2.

with the surface below. The deck gauge wheels should



follows:

If the gauge wheels have excessive clearance or contact with the

surface, adjust as follows:

Raise the deck lift handle to its highest setting.a.

Remove the front and rear gauge wheels by b.

removing the lock nuts and shoulder screws which



c.

height setting.

Reinsert the shoulder screw (with each gauge d.

wheel) into the index hole that leaves approximately



pavement.

Refer to Leveling the Deck in the Maintenance section of this

manual for more detailed instructions regarding various deck

adjustments.

Figure 3-3

Figure 3-4

10 se c t i O n 2 — as s e M b l y & se t -up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Cub Cadet CC4090 Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Grass trimmers Cub Cadet CC4090