Cub-cadet 3184 User Manual download pdf (Page 25)

25

gasket contacts the filter base on

the transmission housing; then

tighten the filter an additional 1/2

turn.

• Clean the area around the

Transmission Oil Fill/Dipstick to

prevent debris from entering the

transmission case.

• Remove the dipstick and SLOWLY

pour oil into the oil fill tube. Fill the

transmission case until the oil level

reaches the “FULL” mark on the

dipstick.

• Reinstall the dipstick securely into

the oil fill tube.

• Start the engine and allow it to run

for a few minutes. Shut the engine

off, then check for leaks and

recheck the oil level in the

transmission case.

Important Information: The service

life and reliability of any machine

depends upon the care it is given.

Proper lubrication is a very important

part of that care. The maintenance

schedule reflects the minimal

requirements to maintain the

equipment. More frequent inspections

and maintenance is preferable.

Using the lubrication illustration as a

guide, make certain that all lubrication

fittings are installed and functioning.

Be sure all fittings are free from dirt

and paint so the lubricant is certain to

enter the bearing.

Using a pressure lubricating gun,

always force the lubricant through the

full length of each bearing until it

emerges at the end, carrying with it

the worn lubricant and any dirt that

may have entered the bearing.

Miscellaneous working parts not

provided with lubrication fittings should

be oiled regularly with a good grade of

lubricating oil.

Always lubricate the tractor thoroughly

before taking it to a remote location for

a prolonged period of time.

Lubricant is cheap. Use plenty of it.

Worn parts can be expensive to

replace.

Keep your supply of lubricating oil and

grease stored in clean containers, and

covered to protect from dust and dirt.

Keep the lubricating gun nozzle clean

and wipe dirt from the grease fittings

before lubricating.

Electrical Box

The electrical box contains the relay

and fuses. See Figure 20 for the

electrical box layout. The electrical box

is located under the upper bulkhead in

front of the dash panel. To access the

electrical box:

• Raise the hood of the tractor

• Locate the locking tabs on the left

and right side of the upper

bulkhead.

• Pull up on the tabs and lift the upper

bulkhead from the tractor.

• Lift the locking tab and remove the

cover from the electrical box.

Figure 20

Fuse

Fuses are installed to protect the

tractor’s electrical system from

damage caused by excessive

amperage.

Relay

Open

25 Amp

Fuses

Open

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Comments to this Manuals

No comments