Cub Cadet GTX1054 Operator's Manual download pdf (Page 22)

Adjustments

WARNING! Shut the engine off, remove the

ignition key and engage the parking brake before

making adjustments. Protect your hands by using

heavy gloves when handling the blades.

NOTE: 

any deck leveling adjustments. Refer to Tires on page 28 for

information regarding tire pressure.

Leveling the Deck (Front To Rear)

The front of the cutting deck is supported by a stabilizer bar that

can be adjusted to level the deck from front to rear. The front of

the deck should be between ⁄inch and ⁄inch lower than the

rear of the deck. Adjust if necessary as follows:

 Park the tractor parked on a firm, level surface and place

the deck lift lever in the top notch.

2. Rotate the blade nearest the discharge chute so that it is

parallel with the tractor.

 Measure the distance from the front of the blade tip to the

ground and the rear of the blade tip to the ground. The first

measurement taken should be between ⁄inch and ⁄inch

less than the second measurement.

Determine the approximate distance necessary for proper

adjustment and proceed, if necessary.

 Locate the hex lock nut on the end of the deck hanger rod.

See Figure 6-4.

 To raise the front of the deck, tighten (thread inward)

the hex nut against the front hanger bracket.

 To lower the front of the deck, loosen (thread outward)

the hex nut, away from the front hanger bracket. See

Figure 6-4.

Figure 6-4

22 Section 6 — Maintenance & adjuStMentS

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Cub Cadet GTX1054 Operator's Manual Page 22