Cub-cadet WO STAGE SNOW THROWER 930 SWE User Manual Page 5
- Page / 28
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
5se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e s
Maintenance & Storage
Never tamper with safety devices. Check their proper 1.
operation regularly. Refer to the maintenance and
adjustment sections of this manual.
Before cleaning, repairing, or inspecting machine 2.
disengage all control levers and stop the engine. Wait until
the auger/impeller come to a complete stop. Disconnect
the spark plug wire and ground against the engine to
prevent unintended starting.
Check bolts and screws for proper tightness at frequent 3.
intervals to keep the machine in safe working condition.
Also, visually inspect machine for any damage.
Do not change the engine governor setting or over-speed 4.
the engine. The governor controls the maximum safe
operating speed of the engine.
Snow thrower shave plates and skid shoes are subject to 5.
wear and damage. For your safety protection, frequently
check all components and replace with original equipment
manufacturer’s (OEM) parts only. “Use of parts which do
not meet the original equipment specifications may lead to
improper performance and compromise safety!”
Check control levers periodically to verify they engage 6.
and disengage properly and adjust, if necessary. Refer
to the adjustment section in this operator’s manual for
instructions.
Maintain or replace safety and instruction labels, as 7.
necessary.
Observe proper disposal laws and regulations for gas, oil, 8.
etc. to protect the environment.
Prior to storing, run machine a few minutes to clear snow 9.
from machine and prevent freeze up of auger/impeller.
Never store the machine or fuel container inside where 10.
there is an open flame, spark or pilot light such as a water
heater, furnace, clothes dryer etc.
Always refer to the operator’s manual for proper 11.
instructions on off-season storage.
Check fuel line, tank, cap, and fittings frequently for cracks 12.
or leaks. Replace if necessary.
Do not crank engine with spark plug removed.13.
According to the Consumer Products Safety Commission 14.
(CPSC) and the U.S. Environmental Protection Agency (EPA),
this product has an Average Useful Life of seven (7) years,
or 60 hours of operation. At the end of the Average Useful
Life have the machine inspected annually by an authorized
service dealer to ensure that all mechanical and safety
systems are working properly and not worn excessively.
Failure to do so can result in accidents, injuries or death.
Do not modify engine
To avoid serious injury or death, do not modify engine in any
way. Tampering with the governor setting can lead to a runaway
engine and cause it to operate at unsafe speeds. Never tamper
with factory setting of engine governor.
Notice Regarding Emissions
Engines which are certified to comply with California and federal
EPA emission regulations for SORE (Small Off Road Equipment)
are certified to operate on regular unleaded gasoline, and
may include the following emission control systems: Engine
Modification (EM), Oxidizing Catalyst (OC), Secondary Air
Injection (SAI) and Three Way Catalyst (TWC) if so equipped.
Spark Arrestor
WARNING! This machine is equipped with an
internal combustion engine and should not be used
on or near any unimproved forest-covered, brush
covered or grass-covered land unless the engine’s
exhaust system is equipped with a spark arrester
meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in effective
working order by the operator. In the State of California the
above is required by law (Section 4442 of the California Public
Resources Code). Other states may have similar laws. Federal laws
apply on federal lands.
A spark arrester for the muffler is available through your
nearest engine authorized service dealer or contact the service
department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
- Op e r a t O r ’s Ma n u a l 1
- To The Owner 2
- Training 3
- Preparation 3
- CALIFORNIA PROPOSITION 65 3
- Maintenance & Storage 5
- Do not modify engine 5
- Notice Regarding Emissions 5
- Spark Arrestor 5
- Safety Symbols 6
- SAVE THESE INSTRUCTIONS! 6
- Assembly & Set-Up 7
- Chute Assembly 8
- Gas & Oil Fill-Up 10
- Controls and Features 11
- Two-Way Chute Control™ 13
- Chute Directional Control 13
- Wheel Steering Controls 13
- Chute Clean-Out Tool 13
- Operation 14
- Replacing Shear Pins 15
- To Engage Drive 15
- To Engage Augers 15
- Operating Tips 15
- Maintenance & Adjustments 16
- Gear Case 17
- Adjustments 17
- Off-Season Storage 18
- Belt Replacement 19
- Changing Friction Wheel 21
- Figure 7-12 22
- Figure 7-11 22
- Troubleshooting 24
- Replacement Parts 25
- 27se c t i O n 10 — nO t e s 27
- CUB CADET LLC 28
- SNOW THROWERS 28
Related products and manuals for Cars Cub-cadet WO STAGE SNOW THROWER 930 SWE
Cars Cub-cadet 930 SWE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 526 WE User Manual
(24 pages)
(24 pages)
Cars Cub-cadet 1130 SWE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 421R User Manual
(20 pages)
(20 pages)
Cars Cub-cadet 522 WE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 721E User Manual
(16 pages)
(16 pages)
Cars Cub-cadet 850 SWE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 521E User Manual
(20 pages)
(20 pages)
Cars Cub-cadet 528 SWE User Manual
(12 pages)
(12 pages)
Cars Cub-cadet 945 SWE User Manual
(27 pages)
(27 pages)
Cars Cub-cadet 724WE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 928 SWE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet 933 SWE User Manual
(32 pages)
(32 pages)
Cars Cub-cadet 926 STE User Manual
(30 pages)
(30 pages)
Cars Cub-cadet 221 HP User Manual
(2 pages)
(2 pages)
Cars Cub-cadet 1345 SWE User Manual
(28 pages)
(28 pages)
Cars Cub-cadet M467 User Manual
(28 pages)
(28 pages)
Revo RCDS30-2 manuals
Owner’s manuals and user’s guides for Security cameras Revo RCDS30-2.
We providing 1 pdf manuals Revo RCDS30-2 for download free by document types: Datasheet
Comments to this Manuals