Cub-cadet ogst3305 User Manual

IMPORTANT: Read Safety Rules and In struc tions Care fully PRINTED IN CANADA OGST-3305Owner’s Man ual¨SET-UP ¨OP ER A TION ¨MAIN TE NANCE

ADJUSTMENTSWARNING: NEVER at tempt toclean chute or make any ad just -ments while en gine is run ning.REMOTE CHUTE ASSEMBLYADJUSTMENTThe re mote chute

ENGINERe fer to en gine man ual for en gine lu bri ca -tion in struc tions.WARNING: When fol low ing in -struc tions in sep a rate en gineman ual

To re move shave plate, re move slideshoes as pre vi ously in structed, re movethe car riage bolts, cupped wash ersand hex nuts which at tach it to t

• Re move the large shoul der bolt andwasher on the left hand side of the en -gine pul ley with an ad just able wrench.See Fig ure 15.NOTE: Ref er en

NOTE: See Ad just ment sec tion for"Au ger Belt Ad just ment".To Remove the Drive Belt:a. Pull idler pul ley away from belt. SeeFig ure 1

• Po si tion the fric tion wheel as sem bly uponto the pin of the shift rod as sem blyand slide the shaft through the fric tionwheel. See Fig ure

TROU BLE SHOOTINGPROB LEM POS SI BLE CAUSE(S) COR REC TIVE AC TIONEn gine fails to start 1. Fuel tank empty, or stale fuel.2. Blocked fuel line.3

THREE (3) YEAR LIMITED WAR RANTYFor three (3) years from the date of orig i nal pur chase of our prod ucts, we will ei ther re pair orre place, at its

IN STRUC TIONS FOR AT TACH INGTHE CHUTE AS SEM BLY • Place chute as sem bly over chuteopen ing, with the open ing in thechute as sem bly fac ing the

SUP PLE MENT

TRAINING1. Read, un der stand, and fol low all in struc -tions on the ma chine and in theman ual(s) be fore at tempt ing to as sem -ble and op er

6. Keep by stand ers, help ers, pets and chil -dren at least 75 feet from the ma chinewhile it is in op er a tion. Stop ma chine ifany one en ters the

10. Plan your snow throw ing pat tern to avoiddis charge to wards win dows, walls, carsetc. To avoid prop erty dam age or per -sonal in jury caused by

ASSEMBLY INSTRUCTIONSNOTE: The snowthrower isshipped with oil and WITH OUTGAS O LINE. Af ter as sem bly, re fer to sep a rate en gine man ual f

• Re move the hair pin clip from the end of the up per chute crank. Slide the up perchute crank into the lower chute crank.Align the holes, and se cur

• Make cer tain the au -ger and drive clutchle vers are in the dis -en gaged (re leased)po si tion. • Move throt tle con trolup to FAST po si -tion

NOTE: Al ways cover vent hole inprimer but ton when push ing. Ad di -tional prim ing may be nec es sary forfirst start if tem per a ture is be low 15°

• Re lease the left hand au ger clutch griponly. The in ter lock mech a nism shouldkeep the left hand clutch en gaged un tilthe right hand clutch