Cub Cadet LT1018 Operator's Manual download pdf (Page 19)

DeckSpindles

Grease fittings can be found on the top of each deck

spindle shaft. See Figure 14. Lubricate with 251H EP

grease or an equivalent No. 2 multi-purpose lithium

grease. Using a grease gun, apply two strokes

(minimum) or sufficient grease to flush old grease and

dirt out of the spindle shaft.

Grease Fitting

FrontWheels

Each of the front wheel axles and rims is equipped with

a grease fitting. See Figure 15. Lubricate with a grease

un after every 25 hours of tractor operation.

Rim Grease Fitting

Figure 15

Figure 14

SECTION8: SERVICE

Tires

_, WARNING: Never exceed the maximum

inflation pressure shown on the sidewall of the

tire.

The recommended operating tire pressure is

approximately 10 psi for the rear tires and 14 psi for the

front tires.

Refer to the tire sidewall for exact tire manufacturer's

recommended or maximum psi. Do not overinfiate.

Uneven tire pressure could cause the cutting deck to

mow unevenly.

HeadLamps

WARNING: If the engine has been recently

run, the engine, muffler and surrounding

metal surfaces will be hot and can cause

burns to the skin. Allow the tractor to cool and

use caution when changing the lamp bulbs.

Replace headlight bulbs as follows:

Lift the hood and locate the headlight wire harness

and lamp sockets

To remove the bulb & socket from the reflector

housing, simply grasp the socket and gently rotate

it 1/4 turn clockwise.

After replacing the bulb, align the tab of the socket

with the notch of the reflector and gently rotate it 1/4

turn counterclockwise.

CuttingBlades

WARNING: Be sure to shut the engine off,

remove ignition key, disconnect the spark plug

wire(s) and ground against the engine to

prevent unintended starting before removing

the cutting blade(s) for sharpening or

replacement. Protect your hands by using

heavy gloves when grasping the blade.

WARNING: Periodically inspect the blade

adapter and/or spindle for cracks or damage,

especially if you strike a foreign object.

Replace immediately if damaged.

The blades may be removed as follows.

Remove the deck from beneath the tractor, (refer to

CuttingDeckRemovalon page 21) then gently flip the

deck over to expose its underside.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Cub Cadet LT1018 Operator's Manual Page 19

Comments to this Manuals

Related products and manuals for Lawnmowers Cub Cadet LT1018